Panasonic WV-CL924A operating instructions Synchronization Setting Sync, Important Notices

6. Synchronization Setting (SYNC)

You can select internal sync mode (INT) or line-lock mode (LL). Additionally, this model accepts the VBS signal (color composite video or blackburst signal) and VS signal (B/W composite video or composite sync sig- nal). The VD2 signal (multiplexed vertical drive signal) with the composite video output signal from external equipment such as a Matrix Switcher is also accept- able.

Whenever the VD2 signal is supplied to this camera, the camera automatically switches to the VD2 sync mode.

1.Move the cursor to the SYNC parameter and select line-lock(LL) or internal(INT).

2.Press .

If LL is selected, the SYNC menu appears. See page 31 (If INT is selected, the synchronization mode is automatically set to internal sync pulse, and the menu is not displayed.)

** CAM SET UP **

CAMERA ID		OFF	↵
ALC/ELC		ALC	↵
SHUTTER		OFF
AGC		ON (DNR-H)
SENS UP		OFF
SYNC		INT
WHITE BAL		ATW1	↵
MOTION DET		OFF
LENS DRIVE		DC
END	SET UP ENABLE

Important Notices:

1.The priority for the sync modes is as follows.

1.Multiplexed Vertical Drive (VD2) (Highest prior- ity)

2.Line-lock (LL)

3.Color Composite Video or Blackburst Signal (VBS)

4.B/W Composite Video or Composite Sync Signal (VS)

5.Internal Sync (INT) (Lowest priority)

2.When the internal sync mode is to be used, select INT. No gen-lock input signal should be supplied to the Gen-lock Input Connector on the rear panel.

3.Whenever the multiplexed vertical drive pulse (VD2) is supplied to the camera from an external equipment such as a Matrix Switcher, the camera sync mode is automatically switched to the VD2 mode.

4.When the VBS or VS gen-lock mode is to be used select INT from this menu and supply the gen-lock input signal to the Gen-lock Input Connector on the rear panel.

5.The VBS gen-lock mode has a submenu for hori- zontal and subcarrier phase adjustments. When the cable length of the video output or the gen-lock input is changed, the horizontal and subcarrier phase must be re-adjusted.

-28-