Panasonic WV-CL924A operating instructions ALC Mode with Preset OFF

Page 23

** ALC CONT **

BACK LIGHT COMP

PRESET

 

OFF

 

 

MASK SET

 

LEVEL

 

...I

 

 

-

 

+

RET

END

 

 

 

 

 

** ALC CONT **

 

 

BACK LIGHT COMP

 

PRESET

 

 

 

 

 

ON

 

LEVEL

 

...I

 

 

-

 

+

RET

END

 

 

 

 

2.Move the cursor to the PRESET parameter and select ON.

The backlight compensation is automatically set.

3.If you want to change the video output level (pic- ture contrast), move the “I” cursor for LEVEL and

adjust the level.

4. Move the cursor to RET and press to return to the CAM SET UP menu.

2-2. ALC Mode with PRESET OFF

These modes are effective when the main object in the scene is not located in the center of the screen and a source of bright light is located near the center of the screen. In these modes, the picture is divided into 48 areas that mask the light to keep the clarity of the pic- ture.

Note: If ELC is selected, set MASK SET and LEVEL according to this procedure.

1.Move the cursor to the PRESET parameter and select OFF.

The item MASK SET appears on the menu.

** ALC CONT **

BACK LIGHT COMP

PRESET

OFF

 

MASK SET

 

 

LEVEL

...I

 

-

+

RET END

-24-

Image 23
Contents Operating Instructions Bol, within an equilateral triangle, is Contents Preface FeaturesHandle the camera with care PrecautionsClean the CCD faceplate with care Do not attempt to disassemble the cameraWV-CL924 Major Operating Controls and Their Functions1Gen-lock Input Connector GEN-LOCK Auto Iris Lens ConnectorFlange-back Adjusting Ring FB 0Gen-lock Termination Switch Hi-Z, G/L 75Ω4AC/DC Compatible Input Terminal DC 12V IN/AC 24V 3Power Cord SocketWV-CL924 12 V DC/24 V AC ConnectionsWV-CL920 120 V AC 60Hz Recommended wire gauge sizes for 24 V AC line AC Power SupplyInstallation of Auto Iris Lens Connector Mounting the Lens Focus or FLANGE-BACK Adjustment Mounting from the top Installation of CameraCamera Setup Menu SetupATW1 ATW2 AWC Press and hold down for 2 seconds or more Opening the Setup MenuAll Reset Operation Setup OperationImportant Notice Editing the CAM SET UP MenuTo enter a blank space in the Camera ID Setting ProceduresCamera Identification Camera ID Setting To edit the Camera IDTo determine the display position of the Camera ID Light Control Setting ALC/ELCTo erase all characters in the editing area Back Light Compensation Back Light Comp ALC Mode with Preset onALC Mode with Preset OFF Blinking Gain Control Setting AGC ON/OFF Shutter Speed Setting ShutterElectronic Sensitivity Enhancement Sens UP Important Notices Synchronization Setting SyncVBS Gen-lock Mode Extvbs Page Line-lock Sync Mode LL VS Gen-lock Mode ExtvsPhase Coarse ATW1 Auto Tracing White Balance White Balance Setting White BALAuto-Tracing White Balance Mode ATW Select AWC → Manual Fine Adjustment for AWC ATWMotion Detector Setting Motion DET Lens Drive Lens Drive Signal SelectionSpecial Menu Special Burst BW Prevention of Blooming and Smear To reset to the factory settingsAGC SpecificationsPage Standard Accessories Optional Accessories Panasonic Canada Inc