Panasonic WV-CL924A Auto Iris Lens Connector, Flange-back Adjusting Ring FB, Down Button

Page 7

qAuto Iris Lens Connector

This connector is used to connect the auto iris lens with a 4-pin male connector supplied as a standard accessory (Part No. YFE4191J100).

wFlange-back Adjusting Ring (FB)

This ring is used to adjust the back focal length or picture focus. Rotate this ring upward or downward for a CS-mount lens. In case of using a C-mount lens, adjust it with the C-mount adapter.

eFocus Fixing Screw (LOCK)

rCamera Mounting Screw Hole

This hole is used to mount the camera onto a mounting bracket.

tDown Button ( )

This button is used to move the cursor downward. It is also used to select items in the CAM SET UP menu.

yRight Button ( )

This button is used to move the cursor to the right. It is also used to select the mode and can be used to adjust some levels.

uLeft Button ( )

This button is used to move the cursor to the left. It is also used to select the mode and can be used to adjust some levels.

iUp Button ( )

This button is used to move the cursor upward. It is also used to select items in the CAM SET UP menu.

oSet Button ( )

This button is used to activate an item selected in the CAM SET UP menu.

!0Gen-lock Termination Switch (Hi-Z, G/L 75)

Set this switch to Hi-Z when a gen-lock video input signal is looped through. In all other cases, set this switch to 75 .

!1Gen-lock Input Connector (GEN-LOCK)

This connector is used to connect an external sys- tem for synchronization.

!2Video Output Connector (VIDEO OUT)

This connector is used to connect with the VIDEO IN connector of the monitor.

-7-

Image 7
Contents Operating Instructions Bol, within an equilateral triangle, is Contents Preface FeaturesHandle the camera with care PrecautionsClean the CCD faceplate with care Do not attempt to disassemble the cameraWV-CL924 Major Operating Controls and Their Functions1Gen-lock Input Connector GEN-LOCK Auto Iris Lens ConnectorFlange-back Adjusting Ring FB 0Gen-lock Termination Switch Hi-Z, G/L 75Ω4AC/DC Compatible Input Terminal DC 12V IN/AC 24V 3Power Cord SocketWV-CL920 120 V AC 60Hz ConnectionsWV-CL924 12 V DC/24 V AC Recommended wire gauge sizes for 24 V AC line AC Power SupplyInstallation of Auto Iris Lens Connector Mounting the Lens Focus or FLANGE-BACK Adjustment Mounting from the top Installation of CameraCamera Setup Menu SetupATW1 ATW2 AWC Press and hold down for 2 seconds or more Opening the Setup MenuAll Reset Operation Setup OperationImportant Notice Editing the CAM SET UP MenuTo enter a blank space in the Camera ID Setting ProceduresCamera Identification Camera ID Setting To edit the Camera IDTo erase all characters in the editing area Light Control Setting ALC/ELCTo determine the display position of the Camera ID Back Light Compensation Back Light Comp ALC Mode with Preset onALC Mode with Preset OFF Blinking Gain Control Setting AGC ON/OFF Shutter Speed Setting ShutterElectronic Sensitivity Enhancement Sens UP Important Notices Synchronization Setting SyncVBS Gen-lock Mode Extvbs Page Line-lock Sync Mode LL VS Gen-lock Mode ExtvsPhase Coarse Auto-Tracing White Balance Mode ATW White Balance Setting White BALATW1 Auto Tracing White Balance Select AWC → Manual Fine Adjustment for AWC ATWMotion Detector Setting Motion DET Lens Drive Lens Drive Signal SelectionSpecial Menu Special Burst BW Prevention of Blooming and Smear To reset to the factory settingsAGC SpecificationsPage Standard Accessories Optional Accessories Panasonic Canada Inc