Panasonic WV-CL924A operating instructions Blinking

Page 24

2.Move the cursor to MASK SET and press .

The 48 mask areas appear on the monitor screen. The cursor is blinking in the top left corner of the screen.

Blinking

3.Move the cursor to the area where backlight is

bright, and press to mask that area. The mask turns white. (When the cursor is moved on an area that has already been masked, the mask and cur- sor start blinking.)

Blinking

4.Repeat step 3 to mask the desired area. To cancel masking, move the cursor to that area and press .

Turns to white

Blinking

5.After masking is completed, press for 2 sec- onds or more. The ALC CONT menu appears.

6.If you want to change the video output level (pic- ture contrast), move the “I” cursor LEVEL and adjust the level.

7.Move the cursor to RET and press to return to

the CAM SET UP menu. (To return to the camera

picture, move the cursor to END and press ).

Caution: When an auto iris lens requiring a DC control signal is used, the lens iris is fully opened in ELC mode.

-25-

Image 24
Contents Operating Instructions Bol, within an equilateral triangle, is Contents Features PrefacePrecautions Clean the CCD faceplate with careDo not attempt to disassemble the camera Handle the camera with careMajor Operating Controls and Their Functions WV-CL924Auto Iris Lens Connector Flange-back Adjusting Ring FB0Gen-lock Termination Switch Hi-Z, G/L 75Ω 1Gen-lock Input Connector GEN-LOCK3Power Cord Socket 4AC/DC Compatible Input Terminal DC 12V IN/AC 24VConnections WV-CL920 120 V AC 60HzWV-CL924 12 V DC/24 V AC AC Power Supply Recommended wire gauge sizes for 24 V AC lineInstallation of Auto Iris Lens Connector Mounting the Lens Focus or FLANGE-BACK Adjustment Installation of Camera Mounting from the topSetup Camera Setup MenuATW1 ATW2 AWC Opening the Setup Menu Press and hold down for 2 seconds or moreSetup Operation All Reset OperationEditing the CAM SET UP Menu Important NoticeSetting Procedures Camera Identification Camera ID SettingTo edit the Camera ID To enter a blank space in the Camera IDLight Control Setting ALC/ELC To erase all characters in the editing areaTo determine the display position of the Camera ID ALC Mode with Preset on Back Light Compensation Back Light CompALC Mode with Preset OFF Blinking Shutter Speed Setting Shutter Gain Control Setting AGC ON/OFFElectronic Sensitivity Enhancement Sens UP Synchronization Setting Sync Important NoticesVBS Gen-lock Mode Extvbs Page VS Gen-lock Mode Extvs Line-lock Sync Mode LLPhase Coarse White Balance Setting White BAL Auto-Tracing White Balance Mode ATWATW1 Auto Tracing White Balance Manual Fine Adjustment for AWC ATW Select AWC →Motion Detector Setting Motion DET Lens Drive Signal Selection Lens DriveSpecial Menu Special Burst BW To reset to the factory settings Prevention of Blooming and SmearSpecifications AGCPage Standard Accessories Optional Accessories Panasonic Canada Inc