Page 12 | AXIS 211M Installation Guide |
Unit connectors
Network connector -
Power connector - Mini DC connector.
Audio in - 3.5mm input for a mono microphone, or a
Audio out - Audio output (line level) that can be connected to a public address (PA) system or an active speaker with a
I/O terminal connector - Used in applications for e.g. motion detection, event triggering, time lapse recording and alarm notifications. It provides the interface to:
•1 transistor output - For connecting exter- nal devices such as relays and LEDs. Con- nected devices can be activated by AXIS VAPIX AP, output buttons on the Live View page or by an Event Type. The out- put will show as active (shown under Event Configuration > Port Status) if the alarm device is activated.
Pin 4 | Pin 2 |
Pin 3 | Pin 1 |
Terminal connector. Note that the pins are numbered
•1 digital input - An alarm input for connecting devices that can toggle between an open and closed circuit, for example: PIRs, door/window contacts, glass break detectors, etc. When a signal is received the state changes and the input becomes active (shown under Event Configuration > Port Status).
•Auxiliary power and GND
Function | Pin number | Notes | Specifications |
|
|
|
|
GND | 1 |
|
|
|
|
|
|
5V DC Power | 2 | Can be used as an alternative power supply | Max load = 100mA |
|
|
| |
|
| +5VDC (100mA). |
|
|
|
|
|
Digital Input | 3 | Connect to GND to activate, or leave float- | Must not be exposed to |
|
| ing (or unconnected) to deactivate. | voltages greater than |
|
|
| 20VDC |
|
|
|
|
Transistor | 4 | Connects to GND when activated. If used | Max load =100mA |
Output |
| with an external relay, a diode must be con- | Max voltage = 24VDC |
|
| nected in parallel with the load for protec- | (to the transistor) |
|
| tion against voltage transients. |
|
|
|
|
|