Axis Communications 2401 Using the Audio Module with Your Video Server, Full-Duplex, Half-Duplex

AXIS 2400/2401 Admin Manual The AXIS 2191 Audio Module 35

Using the Audio Module with Your Video Server

Your audio module is now configured and ready for use with your video server. Enter the server’s IP-address in Internet Explorer, or click Home on the server’s admin page. You should then see the control panel for the AXIS 2191 below the image. If no audio controls are visible, check that you have selected the audio module for use on COM2.

Push-To-Talk

Used in Half-Duplex or Simplex - Talk mode. The button’s own mode is set in the server’s admin pages.

Show/Hide Settings

Shows or hides the slider controls and level indicators.

NB. Exactly which controls will be visible below the image depends on the audio mode you are using. For example, the Push-to-Talk button will not be visible in Full-Duplex mode. Similarly, when using Simplex - Listen mode, only the Speaker controls will be shown. The audio mode is set in the server’s admin tools.

Available Bandwidth

Select the bandwidth available for your connection.

Level Adjust IN/OUT	Mute Checkboxes
Drag sliders to adjust level.	Check to mute speaker or microphone.

Using the Different Audio Modes

Full-Duplex

Full-Duplex mode means that you can transmit and receive audio (talk and listen) at the same time, without having to use any of the controls. This is just like having a telephone conversation. The only controls you may wish to use are the mute checkboxes to turn off the sound, and the level sliders, to adjust the input/output levels. This mode requires a full-duplex sound card on your computer. If your available bandwidth is 0.2Mbit/s or less, it is recommended that you use Half-Duplex mode instead.

Half-Duplex

Half-Duplex mode also sends and receives audio in both directions, but only in one direction at a time. This means you must actively transmit with the help of the Push-to-Talkbutton. To speak, press the button (check that the microphone is not muted). When finished speaking, release the button. You will now be receiving audio from the other end of the connection. Note that the Push-to-Talk button can be configured for use in two different ways - Toggle or Instant. This is set in the server’s admin tools. Half-Duplex mode is best if you only have limited bandwidth available.