| AXIS 2400/2401 Admin Manual | Product Description | 7 |
AXIS 2401 Front Panel
Status Indicator
The
•green - the indicator flashes briefly and momentarily displays orange during the
•red - the indicator will display red only if a problem with the AXIS 2401 has occurred
•orange - flashes orange when reset- ting the factory default settings.
Network Indicator
After completion of the startup and self test routines, the
•yellow - indicating network activity on a 10Mbps Ethernet network
•green - indicating network activity on a 100Mbps Fast Ethernet network
•red - indicating no physical connection to the network.
DIP Switch
A single line termination for the supported video output. Units are shipped with the line termination enabled; that is, with the DIP switch set in the
Power Indicator 
The Power indicator is normally lit while power is applied. If it is not lit, or it flashes, there is a problem with the AXIS 2401 external power source.
Video Input 
Coaxial BNC connector support- ing a single video source. The physical connection is made using RG59, 75 Ohm coax video cable; with a recommended maximum length of 800 feet (250 meters).
Control Button This button is recessed within the product casing. Using a suitably pointed object, press this button to restore the factory default settings. For further infor- mation, refer to Network Settings, on page 20.
Serial Number
Located on the underside label of the AXIS 2401, the serial number is identical to the Ethernet address of the unit.
Video Output
A single video loopthrough (VIDEO OUT) connected in parallel with VIDEO IN and terminated with a coax/BNC connector. Allows direct connec- tion of an external monitor. Set dipswitch to OFF when in use.