Cisco Systems CIVS-IPC-2621V manual Preparing the 2621 IP Dome Ceiling Tile

Chapter 2 Getting Started

Installing the Cisco Video Surveillance 2621 IP Dome

Figure 2-12 Preparing the 2621 IP Dome Ceiling Tile

1

2

3

4

1

2

3

4

Ceiling tile mounting plate

Ceiling tile

Holes in ceiling tile

Base plate

Step 5 Place the ceiling tile mounting plate over the ceiling tile.

Orient the ceiling tile mount so that it is flush with the back surface of the ceiling tile.

Step 6 Attache the base plate to the ceiling tile and ceiling tile mounting plate using four screws.

Step 7 Put the an category 5 or higher Ethernet cable through the appropriate cable entry hole in the conduit base and connect the cable to the LAN port on the IP dome (see Figure 1-1 on page 1-3).

Caution Do not lift the IP dome by the Ethernet cable.

Step 8 If the IP dome will not receive PoE, put the power cable through the appropriate cable entry hole in the conduit base and connect it to the power input on the IP dome (see Figure 1-1 on page 1-3).

To connect a power cable, use a flat-head screwdriver to depress the brown tabs on the power input and connect bare positive, negative, and ground wires as shown on the label that is affixed to the IP dome.

	Cisco Video Surveillance System 2621 IP Dome User Guide
2-18	OL-24129-02