Cisco Systems CIVS-IPC-2621V manual IP Filter Window, QoS

Chapter 3 Configuring and Managing the IP Camera

Setup Windows

Table 3-3	Advanced Setup Window Options (continued)
Option		Description
QoS
Enable QoS Mode		Check this check box and click the Audio, Video, or Both radio button to
		enable Quality of Service (QoS) for audio streams, video streams, or both
		streams.
		Note QOS applies to Layer 3 only, and is applied to ASF and RTP video
		streams. When QOS is applied to an ASF video stream, DSCP values
		are not distinguished between audio and video streams because they
		are applied to the same stream. When QOS is applied to an RTP
		video stream, DSCP values are distinguished between audio and
		video streams because they are applied to different streams.
DSCP		If you enable QoS, enter the Differentiated Services Code Point (DSCP) to
		be used to process QoS packets.
		The default value is 12.

IP Filter Window

The IP Filter window provides options for controlling access to the IP camera by designating a list of IP addresses that can access the IP camera and a list of IP addresses that cannot access the IP camera.

To display the IP Filter window, access the configuration windows as described in the “Accessing the IP Camera Windows” section on page 2-25, click Setup, then click IP Filter.

If you change any options in the IP Filter window, you must click Save to save the changes. To discard the changes, click Cancel before clicking Save. These buttons appear at the bottom of the window. You may need to scroll down to see them.

Table 3-4describes the options in the IP Filter window.

Table 3-4 IP Filter Window Options

Option

Options

Description

Choose the option that specifies how to control IP addresses from which the IP camera can be accessed:

•Disable—Do not use the IP address filtering feature. In this case, the IP camera can be accessed from a device with any IP address.

•Enable and deny the following IP address—Lets you designate one or more IP addresses or range of IP addresses that cannot access the IP camera. All other IP addresses can access the IP camera.

•Enable and allow the following IP address—Lets you designate one or more IP addresses or range of IP addresses that can access the IP camera. All other IP addresses cannot access the IP camera.

	Cisco Video Surveillance System 2621 IP Dome User Guide
3-10	OL-24129-02