Cisco Systems CIVS-IPC-2621V manual Accessing the IP Camera Windows, Https//192.168.0.100

Chapter 2 Getting Started

Accessing the IP Camera Windows

Accessing the IP Camera Windows

After you perform the initial configuration as described in the “Performing the Initial Setup of the IP Camera” section on page 2-23, follow the steps in this section each time that you want to access the IP camera windows to make configuration settings or view live video.

You access these windows by connecting to the IP camera from any PC that is on the same network as the IP camera and that meets these requirements:

•Operating system—Microsoft Windows 2000, Windows XP, or Vista

•Browser—Internet Explorer 6.x with Service Pack 2, or later

You need this information to access the IP camera windows:

•IP address of the IP camera. By default, the IP camera attempts to obtain an IP address from a DHCP server in your network. If the IP camera cannot obtain an IP address through DHCP within 90 seconds of powering up or resetting, it uses the default IP address of 192.168.0.100.

•Port number, if other than the default value. Default port numbers for the IP camera are 443 for HTTPS and 80 for HTTP. The IP camera administrator can enable an alternative HTTPS port and an alternative HTTP port as described in the “Advanced Setup Window” section on page 3-7.

•Your user name and password for the IP camera. The IP camera administrator configures user names and passwords as described in the “Users Window” section on page 3-12.

To access the IP camera windows, follow these steps:

Procedure

Step 1 Start Internet Explorer and enter the following in the address field:

protocol://ip_address:port_number

where:

•protocol is HTTPS for a secure connection or HTTP for a non-secure connection. You can use HTTP only if you configure the camera to accept non-secure HTTP connections as described in the “Performing the Initial Setup of the IP Camera” section on page 2-23.

•ip_address is the IP address of the IP camera. The default IP address is 192.168.0.100.

•port_number is the port number that is used for HTTPS or HTTP connections to the IP camera. You do not need to enter a port number if you are connecting through the default HTTPS port 443 or the default HTTP port 80.

For example,

•Enter the following for a secure connection if the IP address is 192.168.0.100 and the HTTPS port number is 443:

https://192.168.0.100

•Enter the following for a secure connection if the IP address is 203.70.212.52 and the HTTPS port number is 1024:

https://203.70.212.52:1024

•Enter the following for a non-secure connection if the IP address is 203.70.212.52 and the HTTP port number is 80:

http://203.70.212.52

	Cisco Video Surveillance System 2621 IP Dome User Guide
OL-24129-02		2-25