6. ADVANCED OPERATION
Question 1:
How to view the live images of the IP Camera via the Microsoft Internet Explorer on the Desktop PCs or the laptop computers in a situation where there are no monitors or television?
◇The way to get the IP address of the IP Camera without a monitor:
There are three ways to get the IP address: Scan IP, UPnP and IP function.
Scan IP: Please refer to APPENDIX 1.
UPnP: Please refer to APPENDIX 2.
IP function: Please refer to APPENDIX 3.
Question 2:
How to set up the motion detection area and its sensitivity? How to record into the SD card for 30 seconds when the motion has been activated and use the Microsoft Internet Explorer to view the recorded files?
◇Set up the motion detection
1.Click the Application button in the home page.
2.Click the Motion detection button on the left side of the page to enter the “ALARM – MOTION DETECTION” page.
3.Click and drag the mouse left button across a targeted zone to draw a red rectangle on the image. You can also draw the other targeted zones as you wish.
4.Please Enable the motion detection function.
5.Set up the sensitivity level from: Lowest, Low, Medium and High to Highest.
6.Click the Submit button to submit the setting.
◇Recording the images into an SD card while the motion detection function is working
1.Click the Application button in the home page.
2.Click the Enable button below the ALARM item on the left side of the page to enter the “ALARM APPLICATION ENABLE SETTING” page.
3.Tick on “Enable ALARM-SAVE into SD Card” to activate it.
80