deXlan MPEG4 user manual Appendix, Troubleshooting

Page 47

Appendix

A. Troubleshooting

Status LED

After powering up, the Network Camera performs a self-diagnostic to detect any hardware defects. The following table lists the LED patterns in general. In case of any fatal error, the LED will blink in a pattern other than those below.

Condition	LED color

During self-diagnostic after power on	Blink in interchanged green and red

Ethernet signal is lost	Red LED is blinking till Ethernet is detected

Before network is setup	Steady green till IP address is confirmed

After network is setup	Blink green every second

Any hardware failure	Other patterns

Reset and Restore

Wireless model only

Restoring the factory defaults

will erase any previous settings. Reset or restore the system after power on.

At the left side of the camera there is a button hidden in the pinhole as shown in the picture. It is used to reset the system or restore the factory default settings. Sometimes resetting the system sets the system back to normal state. If the system problems remain after reset, restore the factory settings and install again.

RESET: Poke the wrench to click on the button.

RESTORE:

1.Poke the wrench to press on the button continuously.

2.Wait for self-diagnostic to run twice.

3.Withdraw the wrench as soon as the second self-diagnostic starts.

47

Image 47

Contents MPEG4 Before You Use This Product Page Package Contents To install in Ethernet Hardware InstallationWireless Model Only To install in wireless LAN Wireless Model Only Software Installation Page Page Add Password to Prevent Unauthorized Access Initial Access to the Network CameraCheck Network Settings How to Use Authentication Installing Plug-in Main Screen with Camera View ConfigurationPrimary User’s Capabilities Pan/Tilt Control Buttons Camera ViewClient Settings Url http//Network Camera/protocol.html For Best Real-time Video Images Administrator’s CapabilitiesFine-Tuning for Best Performance Only Quality Images Will Do Somewhere Between Real-time and Clear ImagesOpening Accounts for New Users Protect Network Camera by passwordsMore flexible options for viewers Demo on multiple sites mid-scale serviceProduct demo for e-business Large-scale Service Building a Multimedia Web Attraction SitePage Page Building a Security Application Send snapshots when motion is detected Page 耟Software Revision Upgrade Definitions in Configuration System Parameters User Group Administration General Network SettingsStreaming Wlan Configuration For Wireless Model OnlyPage Smtp Mail & FTPPage Video Codec Parameters Motion Detection Page Event Operation Application SetupWeekly Schedule Sequential Operation Camera Control Area Camera ControlPreset Function Area UPnP and Ddns Settings Remote Controller Viewing System Parameters Factory DefaultViewing System Log Configuring the Network Camera behind a IP Sharing Router Page Appendix TroubleshootingFrequently Asked Questions Page Page Page URL Commands of the Network Camera Restart the Network Camera without warning System Resource URL URLSystem Configuration URL General Format of Command URLNetwork Configuration URL Security Configuration URLDdns & UPnP Configuration URL Mail&FTP Configuration URL Audio/Video Configuration URL Normal image Camera Control URLApplication Configuration URL Image Quality Configuration URLSeconds interval for sequential mode Networking Technical SpecificationsElectromagnetic Compatibility EMC