deXlan MPEG4 user manual Hardware Installation, Wireless Model Only, To install in Ethernet

Page 5

Hardware Installation

Wireless model only

Please verify that your product package contains all the accessories listed in the foregoing Package Contents. Depending on the user’s application, an Ethernet cable may be needed. The Ethernet cable should meet the specs of UTP Category 5 and not exceed 100 meters in length.

Connect the power adapter jack to the Network Camera before plugging in to the power socket. This will reduce the risk of accidental electric shock.

Upon powering up, the device runs through a self-test procedure and the front LEDs will blink between green and red a few times. If self-test passes, the LEDs will shut off and the Network Camera will be on stand-by and ready for software installation. If self-test fails the red LED will blink several times. Refer to Appendix A for troubleshooting.

Wireless Model Only

The Network Camera will first detect Ethernet. If it does not connect to Ethernet, the Network Camera will try WLAN. During the searching and connecting process to the wireless access point or station, the red LED of the Network Camera will flash every second. Until the Network Camera connects to the other wireless device, the red LED will become lighted. Operating in either network mode, the green LED will flash every second as heartbeat to indicate alive.

To install in Ethernet

Make sure the Ethernet is firmly connected to a switch hub. After attaching the Ethernet cable plug in the power adapter. If the LED turns out to be steady green after self-test, go to next paragraph “Software installation”.

5

Image 5

Contents MPEG4 Before You Use This Product Page Package Contents To install in Ethernet Hardware InstallationWireless Model Only To install in wireless LAN Wireless Model Only Software Installation Page Page Add Password to Prevent Unauthorized Access Initial Access to the Network CameraCheck Network Settings How to Use Authentication Installing Plug-in Main Screen with Camera View ConfigurationPrimary User’s Capabilities Pan/Tilt Control Buttons Camera ViewClient Settings Url http//Network Camera/protocol.html For Best Real-time Video Images Administrator’s CapabilitiesFine-Tuning for Best Performance Only Quality Images Will Do Somewhere Between Real-time and Clear ImagesOpening Accounts for New Users Protect Network Camera by passwordsProduct demo for e-business Large-scale Service Demo on multiple sites mid-scale serviceBuilding a Multimedia Web Attraction Site More flexible options for viewersPage Page Building a Security Application Send snapshots when motion is detected Page 耟Software Revision Upgrade Definitions in Configuration System Parameters User Group Administration General Network SettingsStreaming Wlan Configuration For Wireless Model OnlyPage Smtp Mail & FTPPage Video Codec Parameters Motion Detection Page Event Operation Application SetupWeekly Schedule Sequential Operation Camera Control Area Camera ControlPreset Function Area UPnP and Ddns Settings Remote Controller Viewing System Parameters Factory DefaultViewing System Log Configuring the Network Camera behind a IP Sharing Router Page Appendix TroubleshootingFrequently Asked Questions Page Page Page URL Commands of the Network Camera Restart the Network Camera without warning System Resource URL URLSystem Configuration URL General Format of Command URLNetwork Configuration URL Security Configuration URLDdns & UPnP Configuration URL Mail&FTP Configuration URL Audio/Video Configuration URL Normal image Camera Control URLApplication Configuration URL Image Quality Configuration URLSeconds interval for sequential mode Networking Technical SpecificationsElectromagnetic Compatibility EMC