3Com DSA-3CV1001-02 service manual Is aligned with the VCN APs small screw hole. See Figure

30CHAPTER 3: INSTALLING AND OPERATING THE VCN ACCESS POINT

7Insert two of the three short screws provided into the farthest indented holes (Figure 19) and drive them to the distance indicated in Figure 20.

Figure 19 Driving Two Screws into the Table

Figure 20 Offset of the Screw Head from the Table

2 .5 -	7/64
3m	in .
m

8Align the two large holes of the VCN AP (see Figure 21) with the two already driven screws.

9Insert the screw heads into the holes and then shift the VCN AP forward so that the screw shanks slip into the slots and the closest indented hole

is aligned with the VCN AP's small screw hole. See Figure 22.