| Connect: You can select the wireless access point you wish to |
| connect here.** |
| SSID: the SSID of all found wireless access points will be |
| shown here. Some wireless access point may hide their |
| SSID, in this case, you have to identify them by their MAC |
| address. |
| MAC Address: If you there are many wireless access points in |
| proximity or some wireless access point hides it’s SSID, you |
| can use MAC address to distinguish them. |
| Signal: Shows the radio signal strength in percent. |
| Channel: Shows the radio channel of this wireless access |
| point. |
| Encryption: Shows the encryption type used by this wireless |
| access point. You must use the same encryption type if you |
| wish to connect to a certain wireless access point. If the |
| wireless access point does not use encryption, ‘Disabled’ will |
| be displayed here. |
| Network Type: Shows the network type of a certain wireless |
| access point (Infrastructure or Adhoc). |
|
|
SSID | Input the SSID of the wireless access point you wish to |
| connect. It should be less than 32 alphanumerical characters. |
| When you select a wireless access point above, it’s SSID will |
| be filled in this field automatically. However, if the SSID is not |
| displayed (the wireless access point you selected choose to |
| hide it’s SSID), you have to know it’s SSID and input it here, or |
| you will not be able to connect it. |
|
|
Channel | Select the radio channel you wish to use here. When network |
| type is ‘Infrastructure’, the radio channel is |
| according to the channel that wireless access point uses. You |
| can only select the channel number when network type is |
| ‘Adhoc’. |
|
|
Basic Rate | Select the maximum wireless data transfer rate here, from |
|
|