Airlink101 AICN1747W user manual Motion Detect

Page 35

4.7 Motion Detect

*This function can only be configured in Windows Internet Explorer.

The Motion Detect menu contains the command and option that allow you to enable and set up the motion detection feature of the camera. The camera provides two detecting areas.

To enable the detecting area, select Window 1 or 2 from the pull-down list, and then check Enable. When the detecting area is enabled, you can use the mouse to move the detecting area and change the area coverage.

-Name: Assign a name to the detecting area.

-Threshold: Move the slide bar to adjust the level for detecting motion. Make sure the threshold (the horizontal line) is low (sensitive) enough to come across the waves (appear when motion detected), so that the events (i.e, emailing snapshot, FTP uploading) you set up in Event Config will be triggered.

NOTE Sliding the Threshold bar to the right will decrease the sensitivity of motion detection; sliding the Threshold bar to the left will increase the sensitivity of motion detection.

- 34 -

Image 35

Contents User’s Manual CH Apter Softw are Inst ALL Ation CH Apter Introduction to Your Camera Checking the Package ContentsGetting to Know Your Camera Front ViewPage Features and Benefits RAM 512MB Accessing the Camera using Web BrowserSystem Requirement NetworkingInstalling the Wall Mount Kit Chapter Hardware InstallationConnecting the Camera to LAN/WLAN Applications of the Camera Click on Install Utility and Software Installing SkyIPCam UltraViewPage Configuring the Camera Page Page Page Viewing Images Method a Access Camera from SkyIPCam UtilityPage Page Basic Using the Web ConfigurationBasic Setup Basic SystemDate & Time Basic Date & TimeGuest AdministratorBasic User General UserNetwork Network Network SettingsIP Setting Ports Number Ddns SettingUPnP Deny IP List Network IP FilterStart/End IP Address WPA2-PSK Network Wireless SettingPage Select PBC Mode Recommended Network Wireless WPS SettingSelect PIN Mode Pan & Tilt Pan & Tilt Settings Pan/Tilt SettingsVideo & Audio Camera Setting up Video & AudioImage Setting Overlay SettingMjpeg Video & Audio VideoCamera Speaker Out Video & Audio AudioCamera Microphone Event Server Setting FTP Event Server ConfigurationEvent Server Setting Email Motion Detect Event Configuration General Setting Event ConfigurationEvent Configuration Arrange Schedule Profile Event Configuration Motion Detection Trigger Event Configuration Gpio Trigger Event Configuration Schedule TriggerUpdate Firmware Factory ResetSystem Reboot ConfigurationSystem Log InformationDevice Info Starting the Program Chapter Using Skyipcam UltraviewMain Window and Item Feature Talk On/Off. Click to enable/disable the speaker Number 1~8 from the Go button Adding a Camera Accessing the CameraPage TIP Editing / Deleting a Camera Viewing Image of the Camera Enabling / Disabling Recording Recording / Playing VideoConfiguring the Recording Settings Setting up Schedule for Recording Playback the Recording Files Configuring the eMap View Setting Page To view from eMap Page Editing / Deleting the eMap User Management Configuring the SystemConfiguring Event Trigger Setting up Event Server Sending Email Notification Changing System Language Terminating Operation Specification Humidity Gpio Terminal Application Connector Pin AssignmentInterface Schematic Numbers Glossary of TermsHEX Java Smtp WEP Technical Support