Select, Loudness Band, Audio Mute Mute, Beep Tone

CD1213

Select

Press the AUDIO		VOL
CONTROL button (4)		VOL
to step through the
menu of audio	FAD	BAS
functions: volume
(VOL), bass (BAS),	BAL	TRB
treble (TRB), balance	BAL	TRB
treble (TRB), balance
(BAL), fader (FAD),

and volume (VOL). When adjusting audio functions, the unit will automatically exit select mode and return to the normal display after five seconds or when another function is activated.

Bass

Press the AUDIO CONTROL button (4) twice until “BAS” appears in the display. Within five seconds, turn the AUDIO CONTROL (3) clockwise or counter clockwise to adjust the bass from “-10” to “+10”. “00” represents a flat response. The bass level is shown on the display for five seconds or until another function is activated.

Treble

Press the AUDIO CONTROL button (4) three times until “TRB” appears in the display. Within five seconds, turn the AUDIO CONTROL (3) clockwise or counter clockwise to adjust Treble from “-10” to “+10”. “00” represents a flat response. The treble level is shown on the display for five seconds or until another function is activated.

Balance

Press the AUDIO CONTROL button (4) four times until “BAL” appears in the display. Within five seconds, turn the AUDIO CONTROL (3) clockwise (or counter clockwise) to adjust Balance between the right and left speakers from “BAL 10R” (full right) to “BAL 10L” (full left). “BAL L=R” represents an equal balance level between the right and left speakers. The balance position is shown on the display for five seconds or until another function is activated.

Fader

Press the AUDIO CONTROL (4) five times until “FAD” appears in the display. Within five seconds, turn the AUDIO CONTROL (3) clockwise or counter clockwise to adjust balance between the front and rear speakers from “FAD 10R” (full rear) to “FAD 10F” (full front). “FAD F=R” represents an equal balance level between the front and rear speakers. The fader position is shown on the display for five seconds or until another function is activated.

Loudness (BAND)

Press and hold the LOUD/BAND button (5) for two seconds to activate the LOUD feature. When listening to music at low volume levels, this feature will boost the bass and treble ranges to compensate for the characteristics of human hearing. When activated, “LOUD”

appears on the display. Press LOUD/BAND again for two seconds to deactivate this feature.

Audio Mute (MUTE)

Press the MUTE button (6) to mute the audio volume. “MUTE” flashes on the display. Restore volume to the previous setting by pressing the mute button again, adjusting the AUDIO CONTROL.

Equalizer Selector (PEQ)

The equalizer function applies preset sound effects to the unit’s audio output signal. Press the PEQ button on the remote control to activate one of the following operating modes: FLAT, CLASSICS, POP M, ROCK M or DSP OFF. When the equalizer function is activated, the most recently selected bass/treble levels are ignored. If the bass and/or treble levels are adjusted while the equalizer function is active, the equalizer function will revert to FLAT. When the equalizer function is not active, the unit will return to the most recently selected bass and treble levels.

Beep Tone

The beep tone feature allows the selection of an audible beep tone to be heard each time a button is pressed on the face of the radio. To access the Beep Tone menu, press and hold the AUDIO CONTROL (4). Turn the AUDIO