6.SOURCE OPERATIONS (ACCESSORIES)
XM Satellite Radio Operations
This function is available when an XM tuner is connected. This unit can control the following satellite radio receiver:
• XM
Note:
•Be sure to turn off the ACC power before connecting/disconnecting the XM tuner.
Selecting the XM mode | Selecting a band |
1. Press the [SRC] button, and touch the [XM] | 1. Touch the [Band] key to select a band. |
key. | This changes the reception band as follows: |
The system changes to the XM mode. | XM1 ➜ XM2 ➜ XM3 ➜ XM1 ... |
English Owner’s manual
Note:
•If the [XM] key is not displayed or the message “CHECK XM TUNER” is displayed, check the connection with the XM Satellite Radio Receiver.
•The audio output is muted and other button operations are not accepted during channel selection.
●Information displayed during reception
The following information is displayed when the satellite radio cannot be received normally.
•When a channel is being tuned in (no signal is yet received): “LOADING”
•A channel without a broadcast has been selected: “CH UNAVAILABLE”
•A channel not covered by your contract: “CH UNAUTHORIZED”
•When a channel is out of air time: “OFF AIR”
•When no signal is received: “NO SIGNAL”
•When the XM antenna is not connected correctly : “CHECK ANTENNA”
Confirming your Radio ID
1.Touch the [Options] key to display the Options screen.
2.Touch the [Direct] key to display the Key Pad screen.
3.Touch the [0] key, then touch the [ENT] key. Receiving the Channel “0” will display your Radio ID
Switching the operation mode
Usually, the system will operate in the Channel selection mode. You can switch this to the Category selection mode by the following operation.
1.Touch the [CAT] key to switch to the Category selection mode.
If you do not perform operation for 15 seconds, the system will automatically return to the Channel selection mode.
•Touch the [Back] key to switch to the Channel selection mode within 15 seconds.