Clarion owner manual 76 MAX685BT

7. CAUTIONS ON WIRING

English INSTALLATION MANUAL

1.Be sure to turn the power off before wiring.

2.Be particularly careful where you route the wires.

Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.

3.If the fuse should blow, check to see if the wiring is correct.

If a fuse is blown, replace it with a new one of the same amperage rating as the original (15A FUSE).

4.To replace the fuse, remove the old fuse of the power supply cord and insert the new one. (Figure 8)

Note:

•There are various types of fuse holder. Do not let the battery side touch other metal parts.

caution

CAUTION

After the connection, fix the cord by a clamp or insulation tape for protection.

Fuse (15A FUSE)

Fuse holder

5.Connect the CeNET extension cable fully and securely until it locks. When the CeNET extension cable is pulled, hold the slide cap part and pull it towards you. (Figure 9)

•When you want to extend the CeNET cable, use extension cable CCA-520 (2.5 m) or CCA-521 (0.6 m) (each of them is sold separately).

CeNET terminal

Slide cap

CeNET cable (provided with the Navigation System)

Figure 9

Figure 8

76 MAX685BT