DSP operations
4.After the setting, press the
Note:
•If the VSE effect is set to OFF, the adjustment made in “VSE operations” is not reflected in the music source.
Calling VSE BASIC Pattern/USER Pattern
1.Press the
2.Touch the [VSE BASIC] and [VSE USER] key to show BASIC pattern selecting display or USER pattern selection/memory display.
3.In the pattern selecting display, touch the one of pattern key to call corresponding VSE pat- tern.
In this display, pressing the No. button in cor- responding to the [DIRECT] key can also call the VSE pattern.
∗After selecting the VSE pattern, touch the
[MEMO] key to copy the selected pattern to the USER pattern.
∗Touch the [EDIT] key to show VSE adjusting display, in which the properties of currently selected pattern can be adjusted.
∗By pressing the [BAND] button in BASIC pattern selecting display or USER pattern selection/memory display you can switch between the two patterns, BASIC and USER.
●“CAR WIDTH”
Compensates for the width of the car’s inte- rior (lateral direction).
●“DIFFUSE”
Compensates for special impression.
4.Touch the [w] or [z] key to make the ad- justment.
The adjustment range is to 1 to 10 for each time.
5.After making adjustments to a desired pat- tern by repeating the steps 3 and 4, touch the [RTN] key to change over to the BASIC/ USER pattern selection/memory display.
6.Press and hold one of [DIRECT] button for 2 seconds or longer to store the adjusted VSE pattern to the USER memory.
7.To set a title of the stored USER pattern, touch the [TITLE] key to change into the [TITLE INPUT] key.
∗For title inputting method, refer to the section “Entering titles”.
8.Press the [A-M] button to change into the STANDARD display.
Professional mode/P.EQ operations
P.EQ effect ON/OFF
∗The factory default setting is “ON”.
English
Owner’s manual
4.After the selecting, press the
Setting and storing VSE Properties/ Memory into USER Pattern
1.Repeat the steps 1 and 2 of the previous procedure (Calling VSE BASIC Pattern/ USER pattern) to show BASIC pattern se- lecting display or USER pattern selection/ memory display.
2.Touch the [EDIT] key to show the VSE ad- justing display.
3.Select an item to be adjusted by touching [ITEM] key in the VSE adjusting display.
The VSE adjustment contents are as follows:
●“CAR LENGTH”
Compensates for the length of the car‘s inte- rior (longitudinal direction).
1.Press the
2.Touch the [P.EQ ON/OFF] key to select “on” and “off”.
3.Each time the [ON/OFF] key is touched, the on and off statuses are switched alternately.
4.After the setting, press the
Note:
•If the P.EQ effect is set to OFF, the adjustment made in “P.EQ operations” is not reflected in the music source.
VRX835 39