Camco 4, 2.6 manual Subject to technical alterations without prior notice

Page 27

7.0 SPECIFICATION

Frequency Response	20 Hz - 20 kHz ± 0,15 dB
	8 Ω load, 1 dB below rated power
Input Impedance	40 kΩ balanced
Voltage Gain	selectable: 26 dB, 32 dB, or 1,4 V input sensitivity
Protection Circuits	inrush-current limitation, protection circuits against power on/off
	transients, temperature monitoring of transformers and heat-sinks,
	output DC protection, power transistor control, temperature dependent
	SOA protection, intelligent mains fuses protection
Limiter	switchable peak-limiter
Fan	2 temperature dependent speed-controlled axial fans
Ground-Lift	input ground-lift switch on back panel
Indicators	LED’s for ON, SIGNAL, CLIP, indicating additionally Output Current and faults
	for example like DC and High Temp
Input Connectors	3-pin XLR, male and female per channel, pin 2 = inphase
Output Connectors	one 4-pole SPEAKON connector for each output channel
	(bi-amping possible)
Modes of Operation	STEREO, BRIDGE MONO and PARALLEL-MONO
Options	Extended User Interface / E.U.I. - modules for any kind of EQ
THD+N (typical)	< 0,01 %
20 Hz - 10 kHz, 8 Ω load
3 dB below rated power
SMPTE (typical)	< 0,01 %
20 Hz - 20 kHz, 8 Ω load
3 dB below rated power
Damping Factor	> 400
8 Ω load, 1 kHz and below
Dimensions (WxHxD)	483 x 88,9 x 420 mm (19”, 2U)
Net Weight	12,4 kg
Shipping Dimensions (WxHxD)	600 x 600 x 205 mm (0,074 m3)
Shipping Weight	15 kg
	Subject to technical alterations without prior notice

P.27	CAMCO USER MANUAL
	VORTEX POWER AMP SERIES

Image 27

Contents Page For Vortex Models 2.6, 4 Please Refer ALL Servicing to Explanation of SymbolsSafety Replacement Parts Safety CheckServicing Declares that the product with the model name EC Declaration of ConformityManufacturers Name Manufacturers AddressContents Welcome Welcome to CamcoUnpacking Amplifier Vortex The Rear FacilitiesMounting InstallationOn/off Switch PrecautionsWiring Speakon Connection CoolingGround Lift Mode Switch 2 E.U.I. and XLR Connection Mode IndicatorsStereo Operation Parallel-Mono OperationBridge-Mono Operation One-channel mono bridged operation Input Signal Chaining Gain Selector Controls Volume ControlLimiter Switch OperationSee 4.4.1,Clip Limiter and 4.4.3, Speaker Protect Limiter Indicators 1 On / Failure IndicatorsSignal Indicators Clip / Output Current IndicatorsTo disable the Clip Limiter, see 4.2.3, Limiter Switch Mains Protection Inrush Current Limitation Power Amp Over Current ProtectionPower Amp Thermal Protection DC ServoFilter Cleaning Vortex Filter AssemblyFans See .7, Input Signal Chaining Options To Activate CAI Address Selection ProcedureCAI Status Indicator Overview Or Remote Controls CAI CAI allowsOn LED Flashing Sequences Examples of LED Sequences TroubleshootingProblem No Sound Problem No Sound or Sound is too LowProblem No Channel Separation Problem Squeals and Feedback Problem Distorted SoundProblem Music Sounds Frequency Filtered Problem HissPower Consumtion @ 230 Typical Max2 SpecificationOutput Power Signal to Noise-RatioSubject to technical alterations without prior notice Measurements of a typical performance MeasurmentsTHD+N @ 1 kHz, 4 Ohm load vs. input voltage Ch1, Ch2 Ch1, Ch2 Measurements of a typical performance Ohms Ch1, Ch2 Measurements of a typical performanceVortex 2.6 Measurements of a typical performance 1257Warranty Information Shipping Address Expired WarrantyNature Of Problem Owner’s Information Company Name ContactCompany Information Mailing AddressInternet