Camco 2.6, 4 manual Fans, Filter Cleaning, Vortex Filter Assembly

Page 20

4.0 OPERATION

4.7 Fans

The fans mounted in the VORTEX operate permanently, but as long as the temperature remains below 40 °C they run at their slowest speed and can hardly be heard. The highest detected temperature from either channel controls the speed of the fans: above 40 °C the speed is increased until it reaches its maximum value.

4.8 Filter Cleaning

A removable filter system is provided on the air intakes to the cooling system. If the filter becomes clogged, the unit will not cool as efficiently as it should and may produce output levels that are lower than normal due to high heat sink temperatures.

To clean, gently slide the whole plastic filter assembly to the left and release from the front panel. Carefully unclip the outer moulding to reveal the filter. Clean the filter with a mild dishwashing detergent and warm water. Once dry, insert the filter back into the cradle and cover with the surround moulding. Slide the whole assembly to the right to secure onto the front panel.

Spare filter assembly’s may be ordered from your dealer.

3

4

5

VORTEX Filter Assembly

1 Clip Apertures

2 Injection Moulded Cradle

3 Foam Filter

4 Injection Moulded Surround

5 Injection Moulded CAMCO Badge

1

 

2

P.20

CAMCO USER MANUAL

VORTEX POWER AMP SERIES

Image 20
Contents Page For Vortex Models 2.6, 4 Explanation of Symbols Please Refer ALL Servicing toSafety Servicing Replacement PartsSafety Check EC Declaration of Conformity Manufacturers NameManufacturers Address Declares that the product with the model nameContents Unpacking WelcomeWelcome to Camco Amplifier Facilities Vortex The RearInstallation On/off SwitchPrecautions MountingGround Lift Wiring Speakon ConnectionCooling 2 E.U.I. and XLR Connection Mode Indicators Mode SwitchBridge-Mono Operation One-channel mono bridged operation Stereo OperationParallel-Mono Operation Input Signal Chaining Controls Volume Control Limiter SwitchOperation Gain SelectorIndicators 1 On / Failure Indicators Signal IndicatorsClip / Output Current Indicators See 4.4.1,Clip Limiter and 4.4.3, Speaker Protect LimiterTo disable the Clip Limiter, see 4.2.3, Limiter Switch Power Amp Over Current Protection Power Amp Thermal ProtectionDC Servo Mains Protection Inrush Current LimitationFans Filter CleaningVortex Filter Assembly See .7, Input Signal Chaining To Activate CAI Address Selection Procedure CAI Status IndicatorOverview Or Remote Controls CAI CAI allows OptionsTroubleshooting On LED Flashing Sequences Examples of LED SequencesProblem No Channel Separation Problem No SoundProblem No Sound or Sound is too Low Problem Distorted Sound Problem Music Sounds Frequency FilteredProblem Hiss Problem Squeals and FeedbackSpecification Output PowerSignal to Noise-Ratio Power Consumtion @ 230 Typical Max2Subject to technical alterations without prior notice Measurments Measurements of a typical performanceTHD+N @ 1 kHz, 4 Ohm load vs. input voltage Ch1, Ch2 Ohms Ch1, Ch2 Measurements of a typical performance Ch1, Ch2 Measurements of a typical performance1257 Vortex 2.6 Measurements of a typical performanceWarranty Information Expired Warranty Nature Of ProblemOwner’s Information Company Name Contact Shipping AddressInternet Company InformationMailing Address