Kenwood G-EQ300 instruction manual 9 8 H Z, Select the center frequency, Adjust the level, Wide

Page 16

5Select the center frequency.

1 6

5Select the center frequency.

FREQUENCY JOG

6Adjust the level.

EQ.LEVEL

7Select the inclination of the curve.

WIDE/NARROW

8Whenor F3 isadjustmentrequired: of center frequencies F2 and/

Repeat steps 4 to 7 above for each center frequency.

When two curves F1 and F2 or three curves F1, F2 and F3 are set, the curve combining them will be displayed in a few seconds.

Creation of desired equalizer patterns

G-EQ300 (En/K)

9 8 H Z

63 98 160 250 400 625 1k

¦Pressing the FLAT key allows to start adjustment from the flat level position.

Each press switches the display as follows.

1 WIDE

: Curve with a gentle slope.

2NARROW: Curve with a sharp slope.

One the two shall light up.

WIDE NARROW

63	98	160	250	400	625	1k	63		98	160	250	400	625	1k

WIDENARROW

¦One adjusted, the curve remains the same until next time it is pressed.










40		63				98				160					250				400				625						1k			1.5k				2.5k				3.9k				6.3k				10k				16 k
40		63				98				160					250				400				625						1k			1.5k				2.5k				3.9k				6.3k				10k				16 k



















40		63				98				160					250				400				625						1k			1.5k				2.5k				3.9k				6.3k				10k				16 k

¦For finer adjustment, perform the graphic mode operation described

in the following page.

&

Image 16

Contents G-EQ300 INSTRUCTION MANUALKENWOOD CORPORATION GRAPHIC EQUALIZERSafety precautions 2 Before applying powerAC 110-120 / 220-240 V switchable AC voltage selector switchSpecial features ContentsAccessories Check that the following accessories are presentIMPORTANT SAFEGUARDS 3Caution Read this page carefully to ensure safe operationIMPORTANT SAFEGUARDS POWER OFFMaintenance CleaningBefore operation UnpackingSTANDBY indicator 1 MAIN POWER key Switch the unit ON mode 2 ON/STANDBY key3 Standby indicator 5 TAPE indicatorCaution regarding placement Except for U.S.A., Canada Set the TAPE 2 MONITOR switch to the monitoring positionSystem connections 8 manuals of the related componentsAV CONTROL CENTER POWER AMPLIFIER GRAPHIC EQUALIZER CASSETTE DECK Remote ControlAbout the system control connections About the system control operationsSwitching the display modes DisplayPreparation Graphic equalizer display modeTo stop demonstration Demonstration method1 Play a music source 2 Select the “DEMO” mode Operation of MANUAL feature To cancel the equalizer effectOperation of graphic equalizer “FLAT” keyOperation of REFERENCE feature Five exemplary patterns have been preset at the factory3 Set to “REFERENCE” Operation of graphic equalizerPreset equalizer pattern M1 to M5 Preset equalizer pattern R1 to R5Pattern can be created and preset by the user in this mode M5 HeadphonesCreation of desired equalizer patterns Operation in PARAMETRIC mode1 Select the “graphic equalizer display mode” 2 Select the “EQ.ON” mode6 Adjust the level 9 8 H Z5 Select the center frequency 7 Select the inclination of the curve4 Select the frequency band to be adjusted 5 Adjust its level6 Fine adjustment of each frequency band Operation in GRAPHIC modeTo cancel the registered pattern 2Preset the equalizer patternAny equalizer pattern can be preset if it is being dis- played Registration of EQUALIZER pattern1 Play a music source 2 Initiate the GENRE mode 3 Select the genre of music4 Select the desired tone pattern The five of the genre keys are also used as the pattern No. keysTo cancel GENRE mode REVERSE key5 Select the purpose of use of the pattern Major purposes of use provided by the USE keys1 Set the TAPE switch to ON Use of equalizer effect with tapeApplying equalizer effect to tape playback To stop tape playback1 Set the TAPE switch to OFF Tape recording of sound with equalizer effectTo stop tape recording 4 Play the source to be recorded 5 Start recording it onto tapeCompensation for the audio characteristics of the listening room Adjustment of sound to your individual tasteFunctions of the graphic equalizer Functions of graphic equalizerOperation to reset SymptomIn case of difficulty CauseSpecifications Signal to noise ratio IHFGraphic equalizer characteristics Equalizer characteristic variable rangeFor the U.S.A FCC WARNING MEMO Model For your recordsSerial Number