Custom Master TV Setup (Cont.)
(Continued from previous page)
5.Transfer the TV setup menu settings to the commercial controller (PTC):
Note: This step is essential for successful cloning using a USB memory device /
.tll file or a clone programmer. Without this step, the PTC will not contain any of the TV setup menu settings.
Note: The maximum number of channels (analog, digital, and Aux inputs) that can be transferred to the PTC is 141. An attempt to transfer more than 141 channels of any combination will result in a Channel Map of exactly 141 channels; any extra channels will not be available in the PTC Channel Map. For example, if you enabled three Aux inputs in the Installer Menu and Auto Tuning found 141 channels, you must edit the Channel Map to decrease the number of analog/digital channels to (at most) 138.
a)After the TV channel lineup has been edited and channel label icons added, tune to the channel (source) for which you wish to transfer TV setup menu settings.
Note: If you intend to use a clone programmer for cloning purposes, this must be either an analog channel or Aux input.
b)Access the Installer Menu, and press
6.(Optional) Add Custom Channel and Aux Input Labels:
Note:
Access the Installer Menu, and press
7.Verify the TV setup.
As applicable, verify that the channel lineup, channel icons, and custom text labels are correct. Also, make sure the TV features are set per your requirements.
8.(Recommended) Lock the channel lineup.
Access the Installer Menu. Set item 028 CH. OVERIDE to 000 and press OK to lock the channel lineup and restrict access to the TV setup menus. Press OK again to save your changes and exit the Installer Menu.*
The Master TV Setup is now ready to be copied to the predetermined cloning
DIGITAL
MONO STEREO SAP
WXYZ
Custom text label “WXYZ” created
in
028 CH. OVERIDE | 000 |
After verifying the TV Setup, set Installer Menu item 028 CH. OVERIDE to 000.*
*This step prevents end users from accessing channel settings (i.e., the Channel Menu will be inaccessible/ grayed out).
18 |