LG Electronics 47LT770H, 42LT770H, 37LT770H, 32LT770H LT2002 Cloning Notes, LT2002 Clone Programmer

Page 36

Clone Programmer Cloning Procedures (Cont.)

Learning / Teaching a Master TV Setup using an LT2002 Clone Programmer

Caution: If the TV is in LodgeNet PPV Mode (check with the site administrator if you are not certain), do not connect a clone programmer to the GAME CONTROL/MPI port, as this will damage the clone programmer.

Cloning is accomplished using the TV/clone programmer MPI ports for communication (see figure).

LT2002 Cloning Notes

• Read the IMPORTANT CLONING

INFORMATION on page 29 before

beginning any cloning procedures.

• A slow flashing green light indicates

that there are communication

Antenna

or CATV

MPI

Cable

 

problems between the TV and the

 

LT2002. If this is the case, check for

 

a damaged cable, poor contacts, or

 

other connection troubles.

If the status indicator is red, the

 

LT2002 batteries are low and should

 

be replaced. Install four (4) high-

 

quality alkaline AA batteries.

Learning and Teaching is only

 

possible between identical model TVs;

 

however, the LT2002 can store up to

 

three different Master TV Setups.

Learn Setup from Master TV

THE CLONE HAS CONTROL OF THE TV

THE CLONE IS VERSION XX

THE TV IS VERSION

XX

THE SW IS REVISION

XX

CLONE CLOCK = XX:XX

 

TV

CLOCK = XX:XX

 

-PRESS ANY KEY TO CONTINUE.

-DISCONNECT CLONE WHEN DONE.

Ferrite Core (TDK, ZCAT 2035-0930)

LT2002 Clone Programmer

Connect cable to

 

 

 

 

 

 

TV MPI Jack and

 

Status

follow on screen

 

instructions

 

Indicator

 

MPI

 

 

 

 

 

 

 

 

 

 

 

Reset

 

 

 

 

Color

 

• green

 

battery ok

 

• red

 

battery low

 

 

 

Blink pattern

 

 

• slow

 

power on

no communications

• heartbeat power on communications ok

QuickSet II Programmer

LT2002

ZENITH ELECTRONICS CORPORATION, LINCOLNSHIRE, ILLINOIS, USA

1.Ensure the Master TV is set up completely and in Pass-through Mode.

2.Tune/set the TV to an analog channel or Aux input, and then plug one end of the MPI cable into the TV MPI port.

3.If there is a good connection after the LT2002 is connected to the TV MPI port, “THE CLONE HAS CONTROL OF THE TV” message will appear on the TV screen. Press any key on the Installer Remote to access the LT2002 Clone Selection Menu.

4.Press 1 on the Installer Remote to select LEARN FROM TV from the Clone Selection Menu; then press OK to proceed to the Memory Bank Selection Menu.

5.Press 1, 2, or 3 on the Installer Remote to select the clone Memory Bank in which to store the Master Setup. Then, press OK.

CLONE SELECTION MENU

(1) LEARN FROM TV

(2)TEACH TO TV

(3)SET CLONE CLOCK FROM TV

(4)SET TV CLOCK FROM CLONE

(5)DISPLAY TV SETUP

(6)DISPLAY CLONE SETUP

-TO CHANGE MENU ITEMS, PRESS CHANNEL KEYS OR DIGITS.

-TO EXECUTE ITEM, PRESS ON/OFF, POWER, OR ENTER.

SAVE TV SETUP IN SELECTED

CLONE MEMORY

Note: If you choose a Memory Bank that already has a Master device’s setup programmed into it, that setup will be overwritten by the new Master TV Setup.

6.Verify the Learning setup information on the next screen, and then press POWER to transfer the Master TV Setup into the selected Memory Bank on the LT2002.

Learning usually takes about 90 seconds. “LEARNING IN PROGRESS” will be displayed on the screen while the LT2002 copies the Master Setup. When the Learning process is complete, a “LEARNING COMPLETE” message will be displayed.

7.When Learning is complete, disconnect the MPI cable from the Master TV.

(1)MEMORY 1 VER XX REV XX

(2)MEMORY 2 VER XX REV XX

(3)MEMORY 3 VER XX REV XX

(4)RETURN TO CLONE MENU

-TO CHANGE MENU ITEMS, PRESS CHANNEL KEYS OR DIGITS.

-TO EXECUTE ITEM, PRESS ON/OFF, POWER, OR ENTER.

36

206-4214

Image 36
Contents 206-4214 Rev B Copyright 2012 LG Electronics U.S.A., IncFor Customer Support/Service, please call­ Power Cord OverloadingGrounding Disconnect DeviceCleaning Outdoor Antenna GroundingAntenna Grounding According to NEC, ANSI/NFPA Transporting ProductTable of Contents Commercial Mode Overview Setup ChecklistPass-through Mode Installer Menu External MPI ControlFTG Mode Remote Management in FTG ModeProCentric TV Interactive Menu Features ProCentric OperationProCentric Interactive Menu Navigation ProCentric Setup Automated Installation Routine Wizard Before you begin, note the followingProCentric Auto Configuration ProCentric Manual ConfigurationRF Configuration IP ConfigurationUSB Configuration Custom Master TV Setup Clonable TV Setup Menu FeaturesBefore You Begin Cloning MethodsCustom Master TV Setup Procedure Set Installer Menu itemsTurn on the TV Set up TV features Optional Run Auto TuningVerify the TV setup Recommended Lock the channel lineupInstaller Menu Accessing the Installer MenuAcronym Description Using the Installer Menu Exiting the Installer Menu and Activating UpdatesNavigation within the Installer Menu Changing Installer Menu SettingsInstaller Menu Items 000 through Brief Description of Function and CommentsInstaller Menu Items 078 through Rear RGB ENDetailed Descriptions of Installer Menu Items Installer SequenceMute Disable Sleep TimerFeature Level HDMI1 EnableHDMI2 Enable HDMI3 EnableAUX Status Atsc Tune Mode ProcentricBack Lighting Atsc BandPower Savings Data ChannelChannel Icons / Custom Text Labels 2-5-4 + Menu Mode To perform channel editing/labelingCloning Overview Before you begin cloningUSB Cloning Procedures Learn Setup from Master TVUSB Cloning Notes Teach Master TV Setup to Target TV XxLT770H-UA00001.TLL Teach To TV TLL Clone Programmer Cloning Procedures TLL-1100A Cloning NotesTLL-1100A Clone Programmer MPIOptional Set the Clock LT2002 Cloning Notes LT2002 Clone ProgrammerClone Programmer Cloning Procedures FTG Mode of Operation Overview FTG Mode via CPU or EBLFTG Mode via CPU FTG Mode via EBLDetermining the TV Operating Mode TV Setup MenusFunction Menu FTG Mode via CPU From previous Teaching FTG Configuration to a TV Learning FTG Configuration from a TV Optional Manual Configuration / TV Setup Run Auto Tuning Channel SearchFTG Configuration List FTG File Manager Utilities OverviewFTG File Manager Main Screen CLEAR/SAVEFTG Channel Map Configuration Utility Print MAPUpdate FTG Channel Map EditorADD ExitFTG Installer Menu Configuration Utility Configuration SettingsIP Environment Setup Accessing the IP Environment MenuConfiguring the Network Connection Wired Network Connection Wireless Network ConnectionNetwork Connection Wireless network is connected Network StatusIP Stream Control Port Number fields become accessible Wake On LAN Setup ProCentric Application Mode ConfigurationMedia Share Setup Remote Jack Pack / TV Connections & Setup Remote Jack Pack SetupTV Connections HDMI/DVIChecking the Software Versions Upgrading TV/PTC SoftwareSplash Screen Image File Guidelines Downloading a Splash Screen ImageReference Power Consumption Settings StaticReference TV Aux Input Configuration EnableReference b-LAN Setup & Overview TV Standby State TV Power On State001 Default Off PowerReference FTG Mode via EBL Local Configuration USB-to-TTL Serial CableReference RJP Model List & Input Auto-sensing Hierarchy Priority Video AudioReference Restoring Factory Defaults on the TVs Installer Menu Item 117 Fact DefaultAdditional FTG Mode via CPU Options Additional FTG Mode via EBL OptionsReference TV Zone Restrictions Reference Wi-Fi Screen Share OptionReference LT770H Rear and Side Jack Panels Side Jack PanelReference External Speaker Setup Reference Installer Remote Control Typical Key Functions PowerTroubleshooting General TroubleshootingTroubleshooting Flow Chart Controller Quick CheckCommercial Mode Check / FTG Operation Troubleshooting FTG Operation TroubleshootingSymptom Possible Causes Solutions Clone Programmer Troubleshooting Reset Clone Programmer After Static ShockSymptom Possible Causes Possible Solutions Clone ProgrammerGlossary of Terms PTCCPU EBLDocument Revision History / Open Source Software Notice Document Revision HistoryOpen Source Software Notice Date DescriptionFor Customer Support/Service, please call­
Related manuals
Manual 40 pages 22.94 Kb

47LT770H, 42LT770H, 32LT770H, 37LT770H specifications

LG Electronics has made significant strides in the world of display technology with its series of commercial televisions, including the models 37LT770H, 32LT770H, 42LT770H, and 47LT770H. These televisions are designed specifically for businesses, retail spaces, and other commercial usages, focusing on durability, professional performance, and versatile applications.

One of the standout features of the LT770H series is its Full HD resolution. With vibrant colors and crisp images, these displays ensure that content is presented in a clear and engaging manner. This high definition capability is essential for environments that require detailed visuals, such as presentations or advertisements in retail settings.

The LT770H series incorporates LG's advanced panel technology, which optimizes brightness and color fidelity. The screens are designed to perform well in various lighting conditions, making them ideal for areas with high ambient light. The high brightness levels enhance visibility, ensuring that messages remain impactful even in sunlight.

In terms of connectivity, the LT770H series boasts an array of ports, including HDMI, USB, and RS-232C. This versatility allows easy integration with various playback devices and systems, enabling seamless content sharing and display management from multiple sources. Businesses can therefore customize their signage or presentations to suit their needs without compatibility issues.

Additionally, these models feature the LG SuperSign Lite software which simplifies content management. This software allows users to create and schedule content, enabling dynamic displays that can change in real-time to reflect promotions, news, or other relevant information. The intuitive interface of the software makes it accessible for users with varying levels of technical expertise.

Durability is another key attribute of the LT770H series. Designed for continuous operation, these televisions can run for extended periods without overheating or compromising performance. This reliability is crucial for commercial environments where downtime is not an option.

In terms of design, the LT770H series is crafted with a sleek profile, allowing for easy mounting and integration into any environment. The modern aesthetics of these displays contribute to a professional look that complements various commercial settings.

In conclusion, the LG Electronics LT770H series, featuring models 37LT770H, 32LT770H, 42LT770H, and 47LT770H, represents a powerful solution for businesses seeking high-quality display options. With features such as Full HD resolution, superior connectivity, and user-friendly content management, these televisions are tailored for a range of commercial applications. Their durability and design ensure that they meet the demands of any professional environment, making them a reliable choice for businesses looking to enhance their visual communication strategies.