LT2002 Cloning Connections / Teaching Setup
Teaching the Master Setup to Another TV
Connections for the LT2002 to Teach Another TV the Master Setup
Antenna or CATV
Ferrite Core (TDK, ZCAT
$POOFDUDBCMFUP |
|
|
57.1*+BDLBOE |
| Status |
GPMMPXPOTDSFFO |
| |
instructions |
| *OEJDBUPS |
MPI
$PMPS
Reset
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION | XX | ||
THE TV IS VERSION |
| XX | |
THE SW IS REVISION |
| XX | |
CLONE CLOCK= | XX:XX |
| |
TV | CLOCK= | XX:XX |
|
tHSFFO CBUUFSZPL
tSFE CBUUFSZMPX
#MJOLQBUUFSO tTMPX QPXFSPO
no communications
tIFBSUCFBUQPXFSPO
communications ok
QuickSet II Programmer
LT2002
ZENITH ELECTRONICS CORPORATION, LINCOLNSHIRE, ILLINOIS, USA
Target TV | Clone Programmer |
| |
|
|
►If an analog channel is not available, tune the TV to an Aux source, such as
Teach Master TV Setup to Target TV
After Learning is complete, remove the MPI cable from the Master TV, and connect it to the Target TV into which you wish to copy the Master TV Setup. With “THE CLONE HAS CONTROL OF TV” message displayed, press 2 or use either Channel key to select the TEACH TO TV option, and press ON/OFF, POWER, or ENTER. Select the LT2002 memory in which the new setup is located. Press ON/OFF to transfer the new setup and other information to the new TV. Teaching usually takes 2 to 3 minutes. After the “TEACHING COMPLETE” message is displayed, press any key to return to the Clone Selection Menu; then press ON/ OFF, POWER, or ENTER. When finished, detach the MPI cable from the target,
Disconnect TV Power for 15 Seconds
Unplug the AC power cord of the
CLONE SELECTION MENU
(1)LEARN FROM TV
(2)TEACH TO TV
(3)SET CLONE CLOCK FROM TV
(4)SET TV CLOCK FROM CLONE
(5)DISPLAY TV SETUP
(6)DISPLAY CLONE SETUP
This menu should appear after any key is pressed on the Installer Remote.
TEACHING IN PROGRESS,
PLEASE WAIT
This display will appear during Teaching function.
TEACHING COMPLETE
This display will appear after Teaching is complete.
23 |