Changing Source Labels on the Master TV

Reference: Adding Channel Icons / Custom Channel Labels (2-5-4 + MENU Mode)

Editing/Adding Channel Icons and/or Labels

If there is no pre-assigned icon, you can make a custom channel label of up to seven (7) characters to help identify a channel or network. If desired, channel labels can also be added in addition to a pre-assigned icon. You may also add labels for the Aux input sources to clearly identify the devices that are connected to the Aux inputs.

(Icon)

Editing and adding the labels can only be done if there are channels entered into the TV’s Channel Map either by using the method described on the previous page, by cloning, or by using the master remote control from the PPV provider.

Note: A blank letter space is available between “Z” and “!”.

To perform channel editing/labeling, proceed as follows:

1. Enter the TV Installer Menu.

XYZ

NETWORK

2.	Press 2-5-4+ MENU to enter the Channel Label Editing
	Mode.
3.	Add your channel icons and channel labels as
	described in the procedures below. (You can do this

1 2 3 4 5 6 7

(Label)

more than once.)

4. To exit the menu when you are done, press MENU.

Changing a Channel’s ICON on the Master TV

1.With Channel Up/Down, select the channel for which you wish to change the icon.

2.With the ADJ Left/Right arrow, select the thin letter “I” on the Channel ID display.

3.Use the Up/Down arrow keys to select the icon with which you want to identify the channel. (If you know the icon number, enter the number, and press ENTER/SELECT.)

4.Proceed with changing/adding channel labels, or go to the next channel.

Changing/Adding Channel Labels on the Master TV

1.With Channel Up/Down, select the desired channel.

2.Press the ADJ Left/Right arrow repeatedly until the numbers 1 to 7 appear on the display. The number shows the position of the character that can be changed. Number 1 is the first character, number 2 the second character, and so on.

3.Use the Up/Down arrow keys to select the desired character.

4.Proceed to the next number posi- tion or use Channel Up/Down to go to the next channel.

Changing Source Labels on the Master TV

1.Press INPUT to select the desired Aux input source: A/V 1, A/V 2, HDMI Component, RGB, etc.

2.Press the ADJ Left/Right arrow repeatedly until the numbers 0 to 9 appear on the display. The number shows the position of the character that can be changed.

3.Use the Up/Down arrow keys to select the desired character.

4.Press INPUT for the next Aux source, or proceed with changing an icon or changing/adding labels. Use Channel Up/Down to return to channels.

Installer Remote Control Key Functions for Master TV Channel Editing/Labeling Menu

•Channel Up/Down: Tunes in the next channel in scan.

•Left/Right Arrows: Select the item to change. If “I” is shown, the icon can be changed. If a number is shown, it indicates the position of the character that can be changed.

•Up/Down Arrows: Select the icon or the character to be

displayed. Tip: Arrows can be held down for fast scrolling.

•0 – 9: Use to enter the index number of the icon, if known.

•ENTER/SELECT: Changes the icon after the number has been entered.

•INPUT: Changes the Aux input label.

•MENU: Exits the editing process.

206-4118