Reference: LT2002 Cloning Procedure Troubleshooting
Warning: Do not use the LT2002 while any PPV card is installed in TV, or the Clone Programmer and the PPV card will be damaged.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the Clone Programmer behaves strangely after a static shock, use a paper clip or similar instrument inserted through the small hole marked RESET to activate the internal reset switch and restore normal operation. After a reset, check the real- time clock setting. It may be necessary to reset the Clone Programmer clock from a TV containing the correct time.
Note
The LT2002 Programmer is designed to be used with TVs containing the
Clone Programmer Troubleshooting
Symptom | Possible Cause(s) | Possible Solution(s) |
Clone Programmer |
|
|
Clone copies setup in | Not enough time to copy entire TV setup. | Press RESET on Clone Programmer, redo Teach/Learn. |
less than 30 seconds. |
| (Teach/Learn should take a minimum of one (1) minute.) |
Remote does not operate | Wrong Installer Remote. | Only use an LG Installer Remote to operate Clone |
clone. |
| Programmer with TV. |
LED does not blink. | MPI cord not connected. | Connect MPI cord properly, and ensure good connection. |
| TV not turned ON. | TV must be powered ON for Clone Programmer to work. |
| Weak batteries. | Install four (4) fresh AA |
Clone menu hard to read. | Weak signal. | Connect TV to a reliable analog channel signal source. |
No time set. | Time not available. | Set time on a TV, and copy time to Clone Programmer. |
Clone not working. | Clone Programmer problem. | Try a different LT2002 Clone Programmer. |
|
| Reset the Clone Programmer. |
Clone scans channels | Clone should only scan channels once. | Try cloning again. |
more than once. |
|
|
Master and Other TVs |
|
|
Cloning did not work. | Procedure interrupted. | Wait until procedure complete message is displayed. |
| Different TV models. | Cloning is only possible with identical model TVs. |
| Step(s) omitted or not performed. | Refer to pages 20 to 23, and make sure all tasks were |
|
| performed. |
Clone time disappeared. | Batteries were removed. | Batteries must remain installed to retain time settings. |
New setup not present. | TV not reset. | Disconnect |
|
| onds. |
•After cloning operations are complete, unplug the LT2002 from the TV.
•If the TV does not display a picture on the TV (blank screen) after a few seconds, just change channels.
39 |