LG Electronics 37LH265H, 42LH255H, 42LH260H, 42LH250H, 37LH250H Reference b-LAN Setup & Overview

Reference: b-LAN Setup & Overview

Power to the b-LAN module is controlled by Installer Menu item 118 POWER SAVINGS. The default value is 003. The b-LAN module is only powered when the TV is turned ON. See chart below.

	TV Standby State		TV Power On State
Power Savings
	b-LAN Power	MPI Slot	b-LAN Power	MPI Slot
		Power		Power
001	On	Standby	On	Main
003	Off	Standby	On	Main
007	Off	Standby	Off	Main

The b-LAN module is internal to the TV. It allows the Hotel/Institution head end equipment to communicate with the TV for configuration and control. This communication is via the institution’s RF distribution system. The control device at the head end (Example: FMA-LG101) can control multiple TVs. When the TV is first installed, it must be turned ON in order for the head end to be able to communicate with the b-LAN. At this point, if it is desired for the b-LAN to always be pow- ered, including during Standby Mode, disable Installer Menu item 118 POWER SAVINGS by setting it to 001. The new settings will not be active until the b-LAN actually downloads the configuration data to the PTC and the PTC is reset.

If the application only requires use of the MPI card slot, and the embedded b-LAN will not be used, the installer can go into the Installer Menu and enable maximum power savings in both Standby and TV Power On Mode by setting Installer Menu item 118 POWER SAVINGS to 007.

42 206-4118