Commercial Mode Setup for Master TV
This page provides an overview of a Master TV configuration.
Note: Disconnect all Aux inputs. Under certain conditions, Auto Tuning (Channel Search) is disabled if there is an Aux input active.
Commercial Mode Setup Procedure
1.Set Installer Menu Items
(Enter the TV Installer
a.Set Installer Menu item 117 FACT DEFAULT to 001, and press ENTER on the Installer Remote. (This clears all Installer Menu custom settings, channel labels / icons, etc. and reloads the factory default settings.)
b.Set item 003 BAND/AFC, as appropriate.
- Broadcast: Set to | 000. | - HRC: Set to 002. |
- CATV: Set to 001. |
| - IRC: Set to 003. |
c.Set other particular installer items that affect your TV programming net- work. Enable/disable Aux sources, set a Start Channel, etc.
d.After you have adjusted all required Installer Menu item settings, press ENTER on the remote to exit the menu and save your changes.
2.Set Up TV Features
(Channel, Picture, Audio, Lock, Time, Option, Digital Captions, etc. See TV Clonable Options list and TV Menus information.)
3.Run Auto Tuning (Channel Search)
a.(Search for all available channels.) Go to the Channel Menu, access the Auto Tuning option, and follow the
b.Edit the Channel Scan. In the Channel Menu, access the Channel Edit option.
•Add/delete channels per your system requirements.
Note: Physical channel numbers are used to identify virtual channels.
•Add familiar channel trademarks/logos like ABC, CBS, NBC, etc. to the
4.Transfer TV Setup to Internal TV Controller:
5.Add Custom Channel Labels for Analog Channels:
XXLH250H INSTALLER MENU
000 INSTALLER SEQ | 000 |
|
|
UPN | FPGA E0F1 |
PTC V1.00.000 | CPU V3.06.00 |
|
|
Typical TV Installer Menu
Note: The Installer Menu header will vary depending on the TV you are setting up.
117 | FACT DEFAULT | 001 |
|
|
|
003 | BAND/AFC | 00X |
Adjust the settings for these
Installer Menu items.
DIGITAL
MONO STEREO SAP
WXYZ
Custom Text Label “WXYZ” created in
093 RJP AVAILABLE | 001 |
Set 093 RJP Available to 001 if using a
Remote Jack Pack.
128 CH. OVERIDE | 000 |
After Master TV Setup is completed, set item 028 CH. OVERIDE to 000.
Verify TV Setup
At this point, verify that the channel lineup, channel icons, and custom labels are correct. Make sure the TV features are set per your requirements. Set item 028 CH. OVERIDE to 000 to lock the channel scan and restrict Setup Menu access. After the preceding has been completed, the Master TV Setup is ready to be copied to a Clone Programmer (see cloning information in this document).
7 |