Pioneer DEX-P99RS Audio Adjustments Switching left and right channel, Using balance adjustment

	Section
Audio Adjustments	03

Switching left and right channel

You can adjust following functions for left and right channel independently or commonly.

!Adjusting network (NW 1, NW 2, NW 3)

!Fine-adjusting equalizer curve (EQ 2)

1Use MULTI-CONTROL to select the audio function described above.

2Press MULTI-CONTROL and hold to switch between left/right independent mode and left/right common mode.

Each pressing and holding MULTI-CONTROL selects left/right independent mode and left/ right common mode.

3Press MULTI-CONTROL to select left channel or right channel when left/right in- dependent mode has been selected.

Each pressing MULTI-CONTROL selects left channel and right channel.

4Adjust these functions as desired.

Using balance adjustment

You can select a balance setting that provides an ideal listening environment in all occupied seats.

1Use MULTI-CONTROL to select BAL in the audio function menu.

Refer to Introduction of audio adjustments on the previous page.

2Push MULTI-CONTROL left or right to adjust left/right speaker balance.

Each time MULTI-CONTROL is pushed left or right, the left/right speaker balance moves to- wards the left or right.

L 25 to R 25 is displayed as the left/right speaker balance moves from left to right.

Using the position selector

One way to assure a more natural sound is to clearly position the stereo image, putting you right in the center of the sound field. The posi- tion selector function lets you automatically adjust the speakers’ output levels and inserts

a delay time to match the number and posi- tion of occupied seats.

1Use MULTI-CONTROL to select POSI in the audio function menu.

Refer to Introduction of audio adjustments on the previous page.

2Push MULTI-CONTROL left, right or up to select a listening position.

Direction Display Position

Left	Left	Front seat left
Right	Right	Front seat right
Up	Front	Front seats

#To cancel the selected listening position, push MULTI-CONTROL in the same direction again.

About the network function

The network function lets you divide the audio signal into different frequency bands, and then reproduce each of them through sepa- rate speaker units.

You can then make precise adjustments to the reproduced frequency band (with a low-pass filter or high-pass filter), level, phase and other parameters to match the characteristics of each speaker unit.

Audio Adjustments

En 25