Dolby Laboratories DVD & MP3, ZE-200DVD Output Power Amplifier Connection, Fuse, Troubleshooting

INSTALLATION & CONNECTION

OUTPUT POWER AMPLIFIER CONNECTION:

■Connect an external power amplifier correctly according to the following connection dia- gram. Incorrect connection will cause incorrect soundstage and also may cause damage to the speakers.

Note:

In tuner, AUX or DVD stereo mode, the 5.1-CH output is analog.

In 6-CH DVD mode, there is Dolby 5.1-CH output.

FUSE

■The inline fuse is rated 10A. If it needs to be replaced, please only use a identical fuse with identical rating and specs. A wrong fuse value can easily cause a fire or damage the installed equipment.

TROUBLESHOOTING

■If such problem arises during your usage, the troubleshooting guide will settle down all your problems immediately. If it still doesn’t work, please contact professional technici- ans to perform.

Symptom	Cause	Action
	Leads and connectors are incorrectly	Confirm once more that all connections
		are correct.
	connected.
		Press [reset] button again.
Power doesn’t turn on. The unit		Rectify the reason for the fuse blowing.
doesn’t operate.	The fuse is blown.	Then replace the fuse. Be sure to
		replace the fuse with the same rating.
	Noise and other factors are causing	Turn the unit off and then on.
	the build-in microprocessor to operate
		Press [reset] button
	incorrectly.
Operation with the remote control	Battery power is low.	Load a new battery.
isn’t possible. The unit does not
operate correctly even when	Some operations are prohibited with
the appropriate remote control		Retry using another disc.
	certain DVD discs.
buttons are pressed.

30