Blaupunkt RCM 104 Adjusting the seek tuning sensi- tivity, Stereo mono switch FM

Manual seek tuning << >>

Prerequisite: AF is switched off!

•Press << or >> to change the frequency in small steps in upwards/ downwards direction.

If you hold down the right or left part of the rocker switch, then the car radio will move through the stations quickly.

Adjusting the seek tuning sensi- tivity

The set allows you to modify the seek tuning sensitivity.

If “lo” is indicated, the radio will only pick up strong stations (low sensitivity).

If “lo” is deactivated, the radio will also pick up less powerful stations (higher sensitivity). The degree of sensitivity can be separately adjusted for both levels (see chapter “DSC programming“).

Stereo - mono switch (FM)

If reception is poor, you may get better sound quality if you switch to mono:

•Press lo for approximately 2 seconds. The stereo symbol will disappear for mono playback.

Each time the car radio is switched on, stereo playback is activated.

The unit will automatically switch to mono playback under poor reception conditions.

Changing the memory bank (FM)

You can shift between the memory banks I, II, and “T” to store and to recall preset stations. The selected memory bank is indicated in the display.

•Press FMT until the desired memory bank lights up in the display (press re- peatedly if necessary).

Storing stations

Using the preset buttons 1, 2, 3, 4, 5, 6 you can store six stations on each FM memory bank (I, II, T).

In the MW/LW range you can store six stati- ons each.

•Select the waveband with the FMT or M•L button.

•Select a station with the rocker switch (either automatically / or manually << >>).

•Press the desired preset button and hold it down. The radio will be muted and resumes play after approximately 2 seconds.

Now the station has been stored. The activa- ted preset button is indicated in the display.