Blaupunkt RCM 104 operating instructions Station naming

Station naming

Using the ST NAME item of the DSC menu you can enter a name with a maximum of 8 digits for all stored frequencies of memory banks I and II.

Most of the FM stations are RDS stations, the names of which will be shown in the display. The displayed RDS name has priority over all entries specified by the user. If you have named an RDS station, this name will only be shown briefly and be replaced by the RDS name afterwards.

For this reason we recommend that you only name non-RDS stations, which only show their frequency but not the name.

All long-wave stations are provided with a station name at the factory.

To start your entry:

•Choose a station,

•press DSC,

•select item “ST NAME” with rocker switch / and

•press -dB.

The first position is flashing.

•Now select a character with rocker switch /.

You have the choice between the capital letters (A-Z), special characters and the numbers (0-9).

•Use the rocker switch << >> to move to the next position and select a charac- ter.

In this way, up to 8 characters can be en- tered.

Once you have completed the name as desi- red,

•press -dB;

now the entry has been stored.

The display returns to “ST NAME”.

To name the next station:

•Select it with one of the preset buttons (1-6); if required, change the memory bank and/or waveband.

Then start to enter the next name.

To finish the entry,

•press DSC.

You will leave the DSC menu at the same time.

Any name entered for a preset station will be deleted by re-assigning it (either with a name or frequency).

DEUTSCH

PORTUGUES ESPAGÑ OL SVENSKA NEDERLAND ITALIANO FRANÇ AIS