Traffic Memo (TIM)
This set is equipped with a digital speech memory, allowing up to 4 traffic messages
Recalling stored traffic announcements
•Press the TIM button briefly.
When pressing TIM once again, you will hear the message text recorded until that interrup-
DEUTSCH
lasting a maximum of 4 minutes to be auto- matically recorded.
As soon as “TP” is displayed, the system will record all incoming traffic announcements of the adjusted station.
If the priority for traffic announcements is activated (“TA” lights up in the display), the set will also record the traffic messages of the traffic station program within the same radio network (see also “Reception of traffic an- nouncements with
Depending on the length of the new traffic bulletin, the oldest messages will be deleted. If a message is longer than four minutes, the system will display OVERFLOW after four minutes of playback, and release a beep tone to indicate that the message could only be recorded partially.
Warning
The motor antenna could be damaged in a car wash.
If you have installed a motor antenna, then please take into account the corresponding warning note at the end of this chapter.
The display for example shows: NDR2 (sta- tion name or frequency), then briefly T4 14.30 (T4 = traffic message 4, recorded at 14:30). If four traffic messages were recor- ded, then “T4” always represents the most recent announcement, which will also be played first.
Use the 
/
rocker button to switch between T1 and T4.
Hold down the 
/
rocker button to move through the message in forwards/backwards direction quickly.
Press << to go back to the beginning of the currently played message.
The TIM function is switched off by either pressing TIM or >>.
TIM standby mode when the radio is turned off
With this system it is possible to record inco- ming traffic announcements automatically at
You may then recall such messages as des- cribed above.
If you press the TIM button while a traffic announcement is being played (TA lit up in the display), the recording will be interrupted.
tion. | ENGLISH | |
Setting the time in the DSC menu: | ||
| ||
TIM needs the exact time in order to operate |
| |
precisely. The time also has to be |
| |
after every interruption of the power supply. | AIS | |
ed. | FRANÇ | |
• Press DSC and the time will be display- |
| |
• Press << to set the hours or >> to ad- |
| |
just the minutes. | ITALIANO | |
The corresponding value is flashing. | ||
| ||
To change the setting, |
|
• press the rocker button / . |
| |
NEDERLAND | ||
When pressing the | ||
To confirm your entry, |
| |
• press |
| |
working in the DSC menu immediately. |
| |
| ||
SVENSKA | ||
time | ||
Adjusting the TIM standby mode/TIM |
| |
The |
| |
| ||
| ||
planned departure time. TIM will then be | OL | |
active 1.5 hours before and after this adju- | ESPAGÑ | |
| ||
sted time, so that the traffic messages will be |
| |
recorded during a period of three hours. |
| |
| ||
Note: During this period, a motor antenna will | PORTUGUES | |
remain extracted. Please take into account | ||
|
the warning note of the end of this chapter.
37