Traffic Memo TIM, Menu | Blaupunkt RCM 126 instruction

Warning

Danger of damaging the antenna in a car wash

Traffic Memo (TIM)

This set is equipped with a digital speech memory, making it possible to automatically record up to four traffic messages lasting a

maximum of four minutes.

When the radio is switched on and “TP” dis- If you have installed a motor antenna, then

played, the system will record all incoming	please read the relevant warning note at the
messages of the tuned in station.	end of this chapter.

If the priority for traffic announcements is

activated (“TA” shown on the display pan- Setting the clock in the DSC

el), the set will also record the messages	menu
broadcast by the traffic station of the same	TIM needs the exact time in order to oper-
	TIM needs the exact time in order to oper-

programme network (see also “Receiving ate precisely. Note that the clock also has
traffic programme stations with RDS-EON”).	to be reset after any interruption of the pow-
If “TIM ON” is briefly displayed when switch- er supply (flashing time display).
ing off the radio, the TIM standby mode is	• Press DSC and the time will be dis-
active. In this case the deactivated radio will
		played.
be ready to record the traffic information
	• Press << to set the hours or >> to set
broadcast for 90 minutes before and after
		the minutes.
the programmed TIM times.
	The value to be set is flashing.
What is more, the radio will record the traf-
fic bulletins broadcast by the tuned in sta-	To alter the value,
tion for three hours after having turned off	•	press the rocker switch / .
the set.	Once having completed the setting,
Depending on the length of the new mes-
	•	press	or DSC.
sage, the oldest messages are automatically
	Now the clock setting has been stored.
deleted.
	If you have pressed the button, you can
If a message is longer than four minutes,

“OVERFLOW” will be displayed after four immediately			go on working in the DSC
minutes of playback, followed by a beep tone	menu.

indicating that the system was unable to record the message in full.

Programming the TIM standby mode / TIM times

You can programme two TIM times (TIMER 1 and TIMER 2).

For example, TIMER 1 could be the time when leaving home in the morning, TIMER 2 the time when driving home after work.

The TIM times to be programmed should correspond to the approximate times of de- parture. The radio will then record the traffic information broadcast for 90 minutes before

-and after - this time, i.e. lasting a total of three hours.

Attention: During this period, a motor an- tenna will remain extracted. Note the rele- vant warning note at the end of this chap- ter.

		adjusted
start		TIM-TIME		end
	1.5 hours		1.5 hours

The motor antenna will be extracted

•Use the rocker switch / to select “TIMER 1” in the DSC menu.

•Press << or >> to recall the adjusted time.

If “TIM OFF” is displayed, the TIM function is inactive.