KeyCard anti-theft protection system
Two KeyCards are supplied with the unit.
Should you lose or damage a KeyCard, you can obtain a replacement from a specialist dealer.
If you are using two KeyCards, the settings are taken from the first KeyCard.
You can customize the following functions:
Station key assignment, bass, treble, bal- ance and fader settings, loudness, beep volume,
The last state selected such as frequency band, station setting, AF, SCANTIME, seek run sensitivity, ON VOL (volume at switch on), SHARX, is also saved.
Your selected settings are therefore select- ed automatically when you insert your Key- Card.
Switching on the unit
•Switch on the unit with ON.
To insert the KeyCard, disengage the con- trol panel:
•Press the knob 1: the control panel folds down forwards.
•Insert the KeyCard with the contact surface downwards, as shown in the diagram (Arrow 1).
2
1
3
•Slide the card in the direction of the ar- row (2) and engage the control panel (Arrow 3).
The car radio is ready for use.
Should a KeyCard other than that belong- ing to the unit be inserted, CARD ERR” ap- pears on the display.
The unit switches itself off after approx. 10 seconds.
Should a card other than a KeyCard be in- serted (e.g. a phonecard or credit card), “WRONG KC” is displayed for approx. 2 seconds.
In this case, remove the card and insert a KeyCard for the unit.
•Press ON to switch on the unit.
Removing the KeyCard
Disengage the control panel as follows
•Press the knob 1: the control panel folds down forwards.
•Slide the card as far as possible to the right, and remove from the front.
•Engage the control panel.
For safety reasons, the control panel must always be engaged whilst the vehicle is moving.
When leaving the vehicle, open the control panel and remove the Key- Card in order to prevent theft.
Teaching in a second KeyCard/ replacing a KeyCard
An additional KeyCard can be “taught in” whilst the unit is in operation with the first KeyCard.
To “teach in” a second KeyCard:
•Slide the first KeyCard in and switch the unit on.
•Press DSC and use 
/
to select “LEARN KC”.
•Press << or >>.
“CHANGE” appears on the display.
•Remove the first KeyCard and, with “CHANGE” on the display, insert the new KeyCard.
When “READY” or “LEARN KC” appears:
•Press DSC.
ENGLISH
13