70 en Network Communications | Conettix Communications Receiver/ | |
Gateway | ||
| ||
|
| |
|
|
i | Notice! | ||
Disabling the telnet and port 77FE prevents you from accessing the | |||
| changes. | ||
|
|
| |
| 6. | At the Disable Web Server prompt, press Enter to accept the default (N). | |
| 7. | At the Disable ECHO ports prompt, press Enter to accept the default (Y). | |
| 8. | At the Enable Encryption prompt, type y and press Enter. | |
| 9. | At the Change keys prompt, type y and press Enter. | |
| 10. | Type the key and press Enter. | |
|
| The key is 16 bytes (32 characters) long. Enter the key using the | |
|
| ||
| 11. | At the Enable Enhanced Password prompt, press Enter to accept the default (N). | |
| 12. | Type 9 and press Enter to save changes and exit from the telnet session. | |
|
| To confirm that the IP address is configured properly, use the ping utility: | |
| 13. | At the C:\> prompt, type ping <IP Address> and press Enter. | |
|
| Four reply messages are received, confirming the D6100i is communicating on the | |
|
| network | |
| Configuration of the D6100i is complete. | ||
12.5.6 | Configuring for Network Communication | ||
| The following steps allow the D6100i to communicate with the host PC running the D6200 | ||
| Programming Software. | ||
|
| ||
| Notice! | ||
i | For the network communication to function, install a properly configured D6100i. Refer to the | ||
previous sections. If network communications are not installed, further D6200 software pro- | |||
| |||
| gramming using the network is not possible. | ||
|
|
| |
| 1. | On the D6100i keypad, press Menu and enter the default passcode of [6][1][0][0] to | |
|
| enter the programming mode. Press Menu again. | |
|
| ||
| Notice! | ||
i | To change any programming parameter, follow this syntax: | ||
Press Enter. | |||
| Enter the desired value. | ||
| Press Enter again to store the value. | ||
|
|
| |
| 2. | Press Down to view the 6 NETWORK CONFIGURATION then press Enter. | |
| 3. | Press Down to view the 6.2 Network adapter and press Enter. | |
| 4. | Set 6.2.5 Network Adapter Enabled to a value of 1 and press Enter. If the value is not 1, | |
|
| press Enter>[1]>Enter. | |
| 5. | If the D6100i has encryption enabled, Set 6.2.6 Network Encryption Enabled to 1. | |
| 6. | Press Cancel and press Down to view 6.3 Network Automation Connection. | |
| 7. | Press Enter. | |
| 8. | Press Down to view 6.3.6 Network Automation Output Format. | |
| 9. | Type 1 for 6500 mode or 2 for SIA mode and press Enter to enter the selection. | |
| 10. | Press Cancel and press the Down button to view 6.3.7 Device. | |
| 11. | Press Enter. | |
| 12. | Press [1] for automation communication through a network, or [2] for automation | |
|
| communication through the | |
| 13. | Press Cancel and press the Down button to view 6.4 D6200 Network Connections. |
2012.11 08 4998122704 | Installation and Operation Guide | Bosch Security Systems, Inc. |