JVC KD-LH300 manual To erase the input characters, Select a source you want to assign a name to

• About the available

characters, see page 55.

Move the cursor to the next

(or previous) character position.

Repeat steps 3 to 5 until you finish entering the name.

Assigning names to the sources

You can assign names to station frequencies, CDs (both in this unit and in the CD changer), and the external component (Line Input).

After assigning a name, it will appears on the display when you select the source.

Sources	Maximum number of
	characters
Station frequencies	Up to 10 characters (up to
	30 station frequencies
	including both FM and
	AM)
CDs*	Up to 32 characters (up to
	40 discs)
External component	Up to 8 characters
(Line Input)

*You cannot assign a name to a CD Text or an MP3/ WMA disc.

1 Select a source you want to assign a name to.

(For KD-AR3000) (For KD-LH300)

When you select a source, the power automatically comes on.

2 While pressing D DISP, press and hold SEL (select) for more than 2 seconds.

The next-step-operation buttons start flashing.

Ex.: When you select CD as the source

3 Select the character set you want while the first character position is flashing.

Each time you press the

button, the character set

changes as follows:

(A – Z: capital) (a – z: small)

(0 – 9: numbers, and symbols)

4 Select a character.

5

6

7 Finish the procedure while the last selected character is flashing.

To erase the input characters

To erase all the characters at a time, press and hold D DISP for more than 1 second as described in the procedure above.

Notes:

•When you try to assign a name to a 41st disc or to a 31st station frequency, “Name Full” appears and you cannot enter the text entry mode. In this case, delete unwanted names before assignment.

•When the CD changer is connected, you can assign names to CDs in the CD changer. These names can also be shown on the display if you insert the CDs in this unit.

ENGLISH

43