JVC KD-LH401 Removing the trigger arm See Figs.19, Removing the top plate assembly See

3.2.9 Removing the trigger arm (See Figs.19 and 20)

•Prior to performing the following procedure, remove the top cover, connector board and clamper unit.

(1)Turn the trigger arm in the direction of the arrow to release the joint k and pull out upward.

CAUTION:

When reassembling, insert the part m and n of the trigger arm into the part p and q at the slot of the chassis rivet assembly respectively and join the joint k at a time.

Joint k

Trigger arm

Chassis rivet assembly

Trigger arm

Chassis

rivet

assembly

Fig.19

Part p

Part q

Part m

Part n

3.2.10 Removing the top plate assembly (See Fig.21)

•Prior to performing the following procedure, remove the top cover, connector board, chassis unit, and clamper assembly.

(1)Remove the screw H.

(2)Move the top plate assembly in the direction of the arrow to release the two joints r.

(3)Unsolder the wire marked s if necessary.

Fig.20

Top plate assembly

H Joints r

s

Fig.21

1-20 (No.MA063)