JVC KD-LX100 Preparing the remote controller, Installing the battery, Remove the battery holder

	Preparing the remote controller
ENGLISH
	Before using the remote controller:
	• Aim the remote controller directly at the remote
	sensor on the main unit. Make sure there is no
	obstacle in between.
	Remote sensor

KD-LX100

•Do not expose the remote sensor to strong light (direct sunlight or artificial lighting).

Installing the battery

When the controllable range or effectiveness of the remote controller decreases, replace the battery.

1. Remove the battery holder.

1)Push out the battery holder in the direction indicated by the arrow using a ball-point pen or a similar tool.

2)Remove the battery holder.

(back side)

1)

2)

2. Place the battery.

Slide the battery into the holder with the + side facing upwards so that the battery is fixed in the holder.

Lithium coin battery (product number: CR2025)

3. Return the battery holder.

Insert again the battery holder pushing it until

you hear a clicking sound.

(back side)

WARNING:

•Store the batteries in a place which children cannot reach.

If a child accidentally swallows the batteries, immediately consult a doctor.

•Do not recharge, short, disassemble or heat the batteries or dispose of in a fire.

Doing any of these things may cause the batteries to give off heat, crack or start a fire.

•Do not leave the batteries with other metallic materials.

Doing this may cause the batteries to give off heat, crack or start a fire.

•When throwing away or saving batteries, wrap in tape and insulate; otherwise, it may cause the batteries to give off heat, crack or start a fire.

•Do not poke the batteries with tweezers or similar tools.

Doing this may cause the batteries to give off heat, crack or start a fire.

6