2 Press and hold 
¢or 4 
until “M” (manual) starts flashing on the display.
Storing stations in memory
You can use one of the following two methods to store broadcasting stations in memory.
•Automatic preset of FM stations: SSM (Strong- station Sequential Memory)
•Manual preset of both FM and AM stations
ENGLISH
3 Tune into a station you want while “M” is flashing.
Press 
¢ to tune into stations of higher frequencies.
Press 4 
to tune into stations of lower frequencies.
•If you release your finger from the button, the manual mode will automatically turn off after 5 seconds.
•If you hold down the button, the frequency keeps changing until you release the button.
When an FM stereo broadcast is hard to receive:
1 Press MODE while listening to an FM stereo broadcast (the ST indicator lights up while receiving an FM stereo broadcast).
2Press MONO, while “MODE” is still on the display, so that the MO indicator lights up on the display. The sound you hear becomes monaural but the reception will be improved (the ST indicator goes off).
Each time you press the button, the MO indicator lights up and goes off alternately.
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM band (FM1, FM2 and FM3).
1 Select the FM band (FM1–3) you want to store FM stations into.
1Press SOURCE to select
tuner as the source.
2If necessary, press
BAND repeatedly to select the band.
Each time you press the button, the band changes as follows:
FM1
FM2 
FM3 
AM
2 Press and hold both buttons for more than 2 seconds.
“SSM” appears, then disappears when automatic preset is over.
Local FM stations with the strongest signals are searched and stored automatically in the band number you have selected (FM1, FM2 or FM3). These stations are preset in the number buttons
—No.1 (lowest frequency) to No.6 (highest frequency).
When automatic preset is over, the station stored in number button 1 will be automatically tuned in.
9