Audio Authority Car Audio System installation manual Demonstration Network Car Audio

Page 1

å

Demonstration Network

Car Audio

System Installation Manual

2048 Mercer Road, Lexington, Kentucky 40511-1071

Phone: 859-233-4599 • Fax: 859-233-4510

Customer Toll-Free USA & Canada: 800-322-8346

Website: http://www.audioauthority.com

The Access™ Demonstration Network is protected by U.S. Patent numbers 5,422,631 and 5,646,602 with foreign patents pending.

Audio Authority, and the double-A symbol are registered trademarks of Audio Authority Corporation. Access, AccessEZ, AccessPC, SilenTouch, AutoDamping, AutoLimiting, AutoCal, and TheftAlert are trademarks of Audio Authority Corporation. The software imbedded within the Access™ System is not sold, but rather licensed for this product specific use. The original purchaser is licensed to use this software in this product and this application only. Under this license, the software may not be reproduced, copied, disassembled, distributed by any means, licensed, rented, sold, or in any way revealed to or used by a third party.

752-267 9/00

Image 1

Contents Demonstration Network Car Audio Page Contents Introduction Definition of Terms What is the Access System?Product Select Selecting Products in the Access System HOW the Access System WorksBuses 922Access User Interfaces Access System ComponentsControl Panels Full-Featured Control Panel Features includeSwitching Modules Expander Modules System ModuleSystem Specific Components DC Distribution Modules Product Groups Choosing the Correct Switching ModulesHead Units 910Amp Sharing Amplifier Product GroupsSpeakers Ampifier BypassAddress and Other Settings Begin InstallationPreparation Number the Product GroupsDetermine the Module ID settings How to Use These TablesSources, EQs and Amplifiers Speakers Set the Programming Switches Set the Address SwitchesProgramming Switch Settings S M B T D Timeout Minutes and Model Set the Left-Right SwitchSilenTouch and Model Speaker LimitDesignate the Switching Module Locations Installing the System HardwareDetermine Other Module Locations Mount the ModulesBlue Low-Level Buses Install Speaker BusLow-Level Bus Illustration.Low-Level EQ and Amplifier BypassInstall the DC Power Distribution Cables Power Supply Ventilation Choosing the Power Mode for Your DisplaySetting the Parallel Speaker Limits Check Your Work to This Point Install the RF Antenna Distribution SystemObserve correct polarity for all bus connections Rear view of the 902 Control Panel Installing a Control PanelControl Panel Cutout Sizes Control Panel ExpandersBe careful to maintain PSB Cable polarity at both ends Installing Product Select Buttons and Product IndicatorsRemote Power Switch System Module AccessoriesTheftAlert Remote System Reset Testing Network Function902 Page Display Component Hookup Install the First ProductsPage Test Your Initial Product Installation Install the Remaining Products Connect the BatteryTroubleshooting Noise Problems Test Product SelectionDeselecting Products with PSBs Selecting Additional Speaker Pairs with PSBsB System Comparison TheftAlert ProtectionProduct to Switch Module Wiring Diagrams System, DC and Signal Bus Wiring DiagramsAddressing Low-Level Bus Example SystemSystem Bus Speaker Bus DC Bus Amplifier Bypass Addressing System BusAmp Bypass EQ Bypass AMP Shared System 942 916X 932 Ch. High-Level 2-Ch Low-Level Head Unit Example of split Model 910D SetupPower Expander Channel Signal Processor Or Equalizer915X DC EQ Bypass NoteModel 980 System Module / 2- and 6-Channel Hookup Channel Setup for 980EZChannel Amplifier Amplifiers / 2-Channel Hookup916X Amp Bypass NoteBAT+ Amplifiers / 4-Channel Hookup942 Shared Amplifier HookupLeft Speaker Right Left/Right and Mono Speaker HookupLimited Warranty Access WarrantyWarranty Service Procedures Out of Warranty ServiceIndex