Alpine Information, Battery Replacement CDA-9855R only, Case of Difficulty, Basic, Radio

Page 38

Battery Replacement (CDA-9855R only)

Applicable battery: Use two “AAA” sized dry batteries or equivalent.

1 Opening the battery cover

Slide out the battery cover while firmly pressing in the direction of the arrow.

2 Replacing the battery

Insert the batteries, observing the polarities as illustrated.

3 Closing the cover

Slide the cover as illustrated until a click is heard.

Controllable With Remote Control

The CDA-9853R can be controlled with an optional Alpine remote control. For details, consult your Alpine dealer. Point the optional remote control transmitter at the remote control sensor.

Remote control sensor

Connectable to Remote Control Interface Box

You can operate this unit from the vehicle's control unit when an Alpine Remote Control Interface Box (optional) is connected. For details, contact your Alpine dealer.

Information

In Case of Difficulty

If you encounter a problem, please turn the power off, then on again. If the unit is still not functioning normally, please review the items in the following checklist. This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is properly connected or consult your authorized Alpine dealer.

Basic

No function or display.

Vehicle's ignition is off.

-If connected following instructions, the unit will not operate with the vehicle's ignition off.

Improper power lead (Red) and battery lead (Yellow) connections.

-Check power lead and battery lead connections.

Blown fuse.

-Check the fuse of the unit; replace with the proper value if necessary.

Internal micro-computer malfunctioned due to interference noise etc.

-Press the RESET switch with a ballpoint pen or other pointed article.

Radio

Unable to receive stations.

No antenna or open connection in cable.

-Make sure the antenna is properly connected; replace the antenna or cable if necessary.

Unable to tune stations in the seek mode.

You are in a weak signal area.

-Make sure the tuner is in the DX mode.

If the area you are in is a primary signal area, the antenna may not be grounded and connected properly.

-Check your antenna connections; make sure the antenna is properly grounded at its mounting location.

The antenna may not be the proper length.

-Make sure the antenna is fully extended; if broken, replace the antenna with a new one.

Broadcast is noisy.

The antenna is not the proper length.

-Extend the antenna fully; replace it if it is broken.

The antenna is poorly grounded.

-Make sure the antenna is grounded properly at its mounting location.

CD

CD Player/Changer not functioning.

Out of operating temperature range +50˚C (+120˚F) for CD. - Allow the vehicle's interior (or trunk) temperature to cool.

CD playback sound is wavering.

Moisture condensation in the CD Module.

-Allow enough time for the condensation to evaporate (about 1 hour).

Continued

37-EN

Image 38
Contents CDA-9855R DE CDA-9853R Contents Installation and Connections Operating Instructions Never Attempt the Following On handling Compact Discs CD/CD-R/CD-RW Move your finger on the GlideTouch bar to the left or right About the GlideTouch Bar OperationTouch or press the desired position on the GlideTouch bar Getting Started Detaching and Attaching the Front Panel Press TUNE/A.ME to select the tuning modeRadio Listening to RadioTuning to Preset Stations Manual Storing of Station PresetsAutomatic Memory of Station Presets Station Title Search FunctionPress FUNC. to activate the audio function mode Setting RDS Reception Mode and Receiving RDS StationsRecalling Preset RDS Stations Receiving RDS Regional Local StationsReceiving Traffic Information PI Seek SettingPTY Programme Type Tuning Receiving Traffic Information While Playing CD or Radio12-EN Priority PTY Programme TypeDisplaying Radio Text GlideTouch bar under P.PTYPlayback 13-ENScanning Programmes Repeat PlayX. Random Play 14-ENQuick Search Searching from CD TextFile/Folder Name Search concerning MP3/ WMA About MP3/WMATerminology 16-ENSetting Users EQ mode Sound SettingEqualizer Presets 17-ENAdjust the level by turning the Rotary encoder Adjusting and Storing the Parametric Equalizer CurveAdjusting and Storing the Graphic Equalizer Curve Press SOURCE/POWER to set the band width QAbout the Crossover Way modeRecalling the Stored Equalizer Curve 19-ENAdjust the output level by turning the Rotary encoder Adjusting and Storing the Crossover SettingsPress SOURCE/POWER to adjust the slope WAY SystemExample 1. Listening Position Front Left Seat Recalling the Stored Crossover SettingsAbout Time Correction Example 2. Listening Position All SeatsDisplay Setup menu is displayed Setting the Time Correction UnitAdjusting and Storing the Time Correction 22-ENAbout the MX indicator display CDA-9853R only Recalling the Stored Time Correction SettingsSetting the MX Mode 23-EN24-EN Other FunctionsDisplaying the Title/Text Press TitleAbout Title and Text Titling Discs/Stations25-EN Press Title and select the Title DisplayIf a Mono Amplifier is Connected Setting Amplifier LinkErasing Disc Title/Station Title If a 4ch Amplifier is ConnectedIf you want to use colours other than the above Setting the Multicolour IlluminationChanging the Lighting Colour of All the Buttons 27-EN28-EN About i-PersonalizeData Downloading File name of download data shall be AU*****.MP3Setup menu of the selected item is displayed General SettingPlaying MP3/WMA Data Play Mode 29-ENTuner Setting 30-EN31-EN Audio SettingDisplay Setting 32-EN Demo SettingSearching for a desired Song Searching by album name Searching by PlaylistSearching by artist name 33-EN34-EN Random Play Shuffle M.I.XDisplaying the Text Playing MP3 Files with the CD Changer Optional Changer OptionalControlling CD Changer Optional Multi-Changer Selection OptionalRemote Control 36-ENCase of Difficulty Battery Replacement CDA-9855R onlyInformation BasicIndication for CD Changer AudioIndication for CD Player 38-EN39-EN SpecificationsIndication for iPod Mode Bottom side of playerInstallation and Connections 40-ENRemoval Installation41-EN Connections 42-ENAmplifier Link / Vehicle Display Interface Connector 43-EN44-EN To prevent noise/interference in the audio systemAlpine CD Changers Give You More CHM-S630 CHA-S634 CHA-1214Appendix Q9 no