Alpine CDA-9853R, CDA-9855R Detaching and Attaching the Front Panel, Listening to Radio

Detaching and Attaching the Front Panel

Detaching

1 Turn off the unit power.

2 Press (Release) at the upper left side until the front panel pops out.

3 Grasp the left side of the front panel and pull it out.

•The front panel may become hot in normal usage (especially the connector terminals on the back of the front panel.) This is not a malfunction.

•To protect the front panel, place it in the supplied carrying case.

Attaching

1 Insert the right side of the front panel into the main unit. Align the groove on the front panel with the projections on the main unit.

2 Push the left side of the front panel until it locks firmly into the main unit.

2

1

•Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.

•Attach the front panel carefully, holding the sides of the front panel to avoid pushing buttons by mistake.

Radio

SOURCE/	TUNE/
POWER	A.ME BAND

g GlideTouch bar

fFUNC.

Listening to Radio

1 Press SOURCE/POWER until a radio frequency appears in the display.

2 Press BAND repeatedly until the desired radio band is displayed.

FM1 → FM2 → FM3 → MW → LW → FM1

3 Press TUNE/A.ME to select the tuning mode.

CDA-9855R:

DX (Distance mode) → LOCAL (Local mode) →

MANUAL (Manual mode) → DX

CDA-9853R:

DX SEEK (Distance mode) → SEEK (Local mode) → OFF (Manual mode) → DX SEEK

• The initial mode is Distance mode.

Distance mode:

Both strong and weak stations will be automatically tuned in (Automatic Seek Tuning).

Local mode:

Only strong stations will be automatically tuned in (Automatic Seek Tuning).

Manual mode:

The frequency is manually tuned in steps (Manual tuning).

4 Press gor fto tune in the desired station.

Holding down gor fwill change the frequency continuously.

•The ST indicator appears on the display when a stereo FM station is tuned in.

•With the CDA-9855R, you can tune the radio with the GlideTouch bar. Press FUNC. to select the source operation mode. Press the GlideTouch bar under the desired function shown in the function guide display.

8-EN