Preparation, Connecting, 37-EN | Alpine DHA-S690 guide

Preparation

1 Park the vehicle in a flat, safe place. Apply the parking brake, then remove the ignition key.

2 Check the included parts and organize the tools and installation instructions.

Ai-NET cable	RCA Extension cable	Power cable
(5.5m)	(Video signal) (5m)	(5m)

1	2		3		4		5		6
Hexagonal	L-shaped	Floor base		Shouldered			Hexagonal		Double
washer	bracket			hexagonal			bolt		washer
faced				nuts (M6)			(M6x25)		screw
tapping									(M4x8)
screw
(M5x15)
x 4	x 2		x 2		x 8		x 4		x 4
7
Shouldered	Mounting strap		Sheet of			Protective			Disc magazine
hexagonal			dust-prevention			plastic bag
bolts (M6x50)				seals		for shipping
							keys
x 4									x 1
Infrared remote		Remote Control			Battery (CR2025)			Index seal sheet
control unit
(5.5m)

(Double-sided adhesive tape)

3 Disconnect the battery’s minus terminal.

Connecting

1 Connect as described on the basic connection diagram on page 40.

•These instructions also include examples of connections with other products.

(See pages 41 to 43.)

•Check which combination of products you will be using and proceed accordingly.

2 Check that all connections are correct.

3 Connect the battery’s minus terminal.

4 Turn ignition key on and power on the head unit, and switch a source to DVD changer or CD changer, then make sure sound will output correctly.

•Before fixing, make sure the function works. If the function does not work correctly, check the connection again.

5 Turn off the DHA-S690’s power.

6 Remove the ignition key and disconnect the battery’s minus terminal.

•Press the Reset button when using for the first time, etc., or change the car battery.

Reset

• For details, refer to “Initial System Start-Up” (page 9).

Mounting the Remote Control Sensor Unit

•When using a monitor with a built-in remote control sensor, such as the IVA-D105R, the external sensor is not used.

•When mounting the unit with double-sided adhesive tape, make sure the mounting surface is dry and free from dirt or grease.

1Press the double-sided adhesive tape onto the back of the remote control sensor unit.

2 Before completing the sensor mounting, make sure the location selected is within the operating range of the remote control. Peel off the backing of the adhesive tape and press the sensor onto the selected mounting location.

Remote Control

Sensor Unit