• Floor base installation
1 Determine the position under the carpet at which the unit is to be installed.
2 Insert the hexagonal bolts (M6x25) 5 into the floor base 3, then mount directly on the floor using the hexagonal washer faced tapping screws (M5x15) 1.
11
3 
5 | 5 |
3 Make
4 Install on top of the carpet using the shouldered hexagonal washer faced nuts (M6) 4.
1 To install horizontally, attach to the floor using the hexagonal washer faced tapping screws (M5x15) 1.
1
1
2 To install vertically, attach to the floor using the hexagonal washer faced tapping screws (M5x15) 1.
1
1
• Suspension from the Rear Tray
WARNING
Do not damage pipe or wiring when drilling holes.
1 Fasten the L-shaped brackets 2 to both sides of this unit.
Horizontal 4 installation
4
6
2
2
6
•When installing horizontally, make sure that the disc magazine’s slot is on the left side.
Vertical 4 installation
4
•When installing vertically, make sure that the disc magazine’s slot is on the top side.
•Installing directly on the floor
WARNING
Do not damage pipe or wiring when drilling holes.
2 Drill holes about 6mm in diameter and fasten securely with shouldered hexagonal bolts (M6x50) 7 and shouldered hexagonal nuts (M6) 4.
7
7
4 | 4 |
|
Checking Operation
1 Turn the ignition key on and check that the unit is operating properly, referring to the operating instructions.
2 Check that the vehicle’s equipment (horn, stop lights, etc.) are operating properly.