Alpine IVA-D300 owner manual Indication for CD/MP3/WMA, Indication for DVD/Video CD, 63-EN

Page 65

Error displays

•Mechanical error

-Press c. After the error indication disappears, insert the disc again. If the above-mentioned solution does not solve the problem, consult your nearest ALPINE dealer.

MP3/WMA is not played back.

•Writing error occurred. The CD format is not compatible.

-Make sure the CD has been written in a supported format. Refer to “About MP3/WMA” (pages 15 and 16), then rewrite in the format supported by this device.

Unit does operate.

•Monitor’s power is not turned on.

-Turn on the monitor’s power.

•Condensation.

-Wait a while (about 1 hour) for the condensation to dry.

No picture is produced.

•Monitor’s mode is not switched to the mode you want to see.

-Switch to the mode you want to see.

•Monitor’s parking brake lead is not connected.

-Connect the monitor’s parking brake lead and set the parking brake.

(For details, refer to the monitor’s instructions.)

•Monitor’s parking brake is not set.

-Connect the monitor’s parking brake lead and set the parking brake.

(For details, refer to the monitor’s instructions.)

Playback does not start.

•Disc is loaded upside-down.

-Check the disc and load it with the labeled side facing upward.

•Disc is dirty.

-Clean the disc.

•A disc not able to playback with this unit is loaded.

-Check if the disc is able to be played back.

•Parental lock is set.

-Cancel the parental lock or change the rating level.

Picture is unclear or noisy.

•Disc is being fast-forwarded or fast-reversed.

-The picture may be slightly disturbed, but this is normal.

•Vehicle’s battery power is weak.

-Check the battery power and wiring.

(The unit may malfunction if the battery power is under 11 volts with a load applied.)

•Monitor’s fluorescent tube is worn.

-Replace the monitor’s fluorescent tube.

Image stops sometimes.

•Disc is scratched.

- Replaced with a non-scratched disc.

Indication for CD/MP3/WMA

HI-TEMP

•Protective circuit is activated due to high temperature.

-The indicator will disappear when the temperature returns to within operation range.

-Leave the power OFF until the temperature decreases and then turn the power ON again.

NO DISC

•No disc is inserted.

-Insert a disc.

•Although a disc is inserted, “NO DISC” is displayed and the unit does not start to play or eject the disc.

-Remove the disc by following these steps: Press c for at least 3 seconds.

LOADING ERROR

EJECT ERROR

•Mechanism error.

1)Press c and eject the disc.

If not ejecting, consult your Alpine dealer.

2)When the error indication remains after ejecting, press c again.

If the error indication still does not turn off after pressing c for a few times, consult your Alpine dealer.

DISC ERROR

•Scratched disc, contaminated disc/poor recording/disc incompatible with this unit

-Press c.

-Change the disc.

Indication for DVD/Video CD

NO DISC

•No disc is inserted.

-Insert a disc.

•Although a disc is inserted, “NO DISC” is displayed and the unit does not start to play or eject the disc.

-Remove the disc by following these steps: Press c for at least 3 seconds.

•Remote control operation is not possible.

-For some discs or playing modes, certain operations are not possible. This is not a malfunction.

HI-TEMP

•Protective circuit is activated to high temperature.

-The indicator will disappear when the temperature returns to within operation range.

-Leave the power OFF until the temperature decreases and then turn the power ON again.

VIDEO SIGNAL SYSTEM IS

NOT CORRECT

•PAL disc is loaded. - Load an NTSC disc

Continued

63-EN

Page 64 Page 66
Image 65
Page 64 Page 66
Contents IVA-D300 CHA-1214CHM-S630 CHA-S634Contents Monitor Setting Installation and Connections Operating Instructions Precautions Discs playable on this unit ALL Disc terminology Getting Started Using Face CoverLocation of Controls Initial System Start-UpAdjusting the Volume Turning Power On or OffLowering Volume Quickly How to view the Display11-EN Recalling the SourceTouch SRC on the main screen Source selection screen is displayed12-EN Displaying the Numeric Keypad Input ScreenDual-Screen Display 13-EN RadioListening to the Radio 14-EN PlaybackX. Random Play Repeat PlayAbout MP3/WMA 15-EN16-EN TerminologyDVD/Video CD To display the DVD mode screenPlaying DVD/Video CD 17-EN18-EN If a menu screen appearsDirect Menu Operations DVD only Menu Operations DVD onlyStopping Playback PRE Stop Turning the PBC Function on or OFF Video CD onlyStopping Playback Fast-forwarding/Fast-reversingFrame-by-frame Playback Playing Still Frames PausingSlow Motion Playback Chapter/Track/Title Repeat PlaybackSwitching the Audio Tracks Switching the Angle DVD onlySwitching the Subtitles Subtitle Language DVD only Switching from the disc menuAdjusting the Audio Other Useful FeaturesTitling Discs/Radio Stations 22-EN23-EN Disc Search FunctionRear Entertainment Function Switching the function of the remote sensor Switching Display Modes24-EN Touch FRONT, Rear 1 or RearSetting Visualizer Blackout Mode On and OffSetting the Visual Effect Canceling the Simultaneous Function26-EN Monitor SettingMonitor Setting Operation DVD Setup SetupDVD Setup Operation 27-EN28-EN Audio output/Optical digital audio output 29-EN30-EN General SetupGeneral Setup Operation 31-EN 32-EN System SetupSystem Setup Operation 33-EN 34-EN Display SetupDisplay Setup Operation PersonalizeTM Setting the MX modeMedia Xpander Function 35-ENSelecting Bass EQ mode Makers setting Setting the Bass EngineAdjusting and Storing/Recalling the Parametric EQ Bass Engine FunctionRecalling the Adjusted and Stored Contents Storing Adjusted ContentsAbout the Time Correction 37-ENSetting item Bass Focus Setting contents Adjusting and Storing/Recalling the Bass Focus38-EN Example 2. Listening Position All Seats39-EN Adjustment and Storing/Recalling of Time Correction40-EN Visual EQ Setting OperationSubwoofer On and Off 41-EN About Sound Setup DownloadData Download 42-EN Setting AMP Link OptionalData Downloading Displaying Status of External Amplifier External Audio Processor OptionalTitling the Amplifier 43-EN44-EN Setting the SpeakersSet MX Mode of the External Audio Processor 45-EN Over AdjustmentPerforming Time Correction Manually TCR 46-EN Phase SwitchingGraphic Equalizer Adjustments Setting Bass Sound Control Parametric Equalizer AdjustmentsSetting Bass Compressor Setting Bass FocusSetting of Dolby 5.1ch Speaker SetupAdjusting the acoustic image Mixing bass sound to the rear channelStoring Settings in the Memory Adjusting the DVD LevelGetting out the Preset Memory Achieving powerful high volume sound50-EN Using the Pro Logic II ModeLinear PCM Setting 51-EN Operating Auxiliary Devices OptionalTouch NAV Touch AUXControlling CD Changer Optional Changer OptionalMulti-Changer Selection Optional 52-ENXM Radio Optional HDD Player Operation OptionalListening to Music of HDD Receiving XM Channels with the XM Receiver OptionalStoring XM Channel Presets Tuning in to Categorized ProgramsChanging the Display Checking the XM Radio ID NumberDisplaying the Category/Channel Name Title List MobileHub Link OptionalSelecting the Channel directly About MobileHub Link OptionalCalling Telephone ReceptionInformation SMS Short Message Service OperationAbout DVDs Receiving a Short messageDolby Digital TerminologyDolby Pro Logic Linear PCM audio LpcmFor details, see List of Language Codes59-EN 60-EN List of Country Codes61-EN Basic Case of DifficultyRadio CD/MP3/WMA/DVD/Video CD63-EN Indication for CD/MP3/WMAIndication for DVD/Video CD 64-EN Indication for XM radio modeIndication for CD changer 65-EN Specifications66-EN Installation and Connections67-EN InstallationInstalling the Monitor Installing the DC/DC Converter Installing the Tuner BoxWhen mounting with Velcro fasteners 68-ENIf the ACC power supply is not available Connection Diagram of Spst Switch Sold SeparatelyParking Brake Lead Connection Foot Brake Lead / Parking Brake Lead Connection70-EN Connections IVA-D300 Wiring Diagram71-EN 72-EN System ExampleTo Ai-NET Connector Gray To Ai-NET Connector Black Digital Output Terminal Ai-NET Connector73-EN AUX Video Input AUX1 TerminalUse when connecting a back-up camera When Connecting External Equipment74-EN Remote IN/OUT Terminal Camera Input TerminalIVA-D300 Tuner BOX 75-ENALPINE-1 Limited Warranty

IVA-D300 specifications

The Alpine IVA-D300 is a sophisticated in-car audio and video system that epitomizes cutting-edge technology in the realm of automotive entertainment. Designed to elevate the in-car experience, the IVA-D300 combines reliable performance with a sleek interface, making it a popular choice among car enthusiasts and casual users alike.

One of the standout features of the IVA-D300 is its 7-inch motorized touchscreen display. This high-resolution screen ensures clear visuals, whether you're watching movies or navigating through your music library. The touchscreen interface is intuitive, allowing users to easily access their favorite media and settings.

The IVA-D300 supports a wide range of audio and video formats, ensuring compatibility with a variety of devices. With options for DVD playback, CD playback, and even MP3/WMA file support, this unit accommodates nearly all your entertainment needs. Furthermore, it boasts the capability to connect to external devices through USB and auxiliary inputs. This feature allows users to effortlessly link their smartphones or portable music players, enhancing the versatility of the system.

In terms of audio performance, the IVA-D300 offers a powerful 4-channel amplifier with adjustable sound settings. Users can fine-tune their audio experience with a built-in equalizer and various sound enhancement technologies. The inclusion of a built-in crossover also allows for optimal speaker performance by directing specific frequencies to the appropriate speakers.

A noteworthy technological advancement in the IVA-D300 is its support for Bluetooth connectivity. This feature not only enables hands-free calling but also allows for wireless audio streaming from smartphones and other compatible devices. The integration of Bluetooth technology emphasizes convenience and enhances safety, as drivers can focus on the road while staying connected.

Moreover, the IVA-D300 is designed with expanding capabilities in mind. The system can be integrated with various accessories such as satellite radio and rearview cameras, providing users with a more comprehensive multimedia experience.

In summary, the Alpine IVA-D300 is a feature-rich in-car entertainment system that stands out for its advanced technologies and user-friendly design. Its high-quality display, extensive media compatibility, powerful audio features, and Bluetooth connectivity make it an excellent choice for anyone looking to enhance their in-car experience. With the IVA-D300, drivers can enjoy both the journey and their favorite entertainment seamlessly.
Top Page Image Contents