If the PIN code on the SIM card is the same as the PIN in GB 051 and SIM is blocked by PIN, then after setting new PIN to the GB 051 unit the PIN will be changed in both – the SIM and GB 051 unit.
GB 051 replies to this SMS message and draws sender’s attention to necessity of unification of PIN in Remote Supervision and phone and to necessity of
After reception of this SMS message verify correct PIN code change by switching the phone off with the red phone button. If PIN is set correctly and external power supply is connected GB 051 automatically switches on the phone, sets PIN and LED starts to flash in slow rhythm. It signalizes readiness of Remote Supervision for reception and sending messages. At the same time new PIN is entered into memory of GB 051.
It is possible to set up volume of cell phone ringing according to your need in main menu. Ringing of the phone can be eventually switched off completely. It is possible to change or switch off the sound indicating reception of SMS message either. Furthermore, volume of conversation can be changed (only the volume of speaker is concerned).
If SMS centre is not correctly set on SIM card it is necessary to set it up in cell phone menu.
3.4. Indication by LED
Indicating LED on the side of GB 051 indicates basic operating states:
Slow regular flashing | Remote Supervision is prepared for operation |
Occasional short flash | Remote Supervision is prepared but runs from |
| backup battery |
6 quick flashes | Action in progress – after an input is activated |
3 quick flashes | Incoming SMS command message |
Quick flashing | Not ready for ALARM, no connection to the GSM |
4.Programming by SMS Messages
Number of functions and parameters, which allow adjustment of GSM Remote Supervision to environment and user’s requirements can be configured by programming. At the same time programming allows control of functions by user.
Programming can be carried out either remote by SMS message from cell phone or Internet if available - or comfortably using the Control Panel software and the ED 051 011 communication converter with cable connected to the serial port of your PC.
9