Siemens M35 or S35, C35i manual IO1, IO2, IO3, IO4, IO5, IO6, IO7, IO8

Command *1)	Activated by input	Order on the
	No.:	terminal board
XXppppSMSNOA1Vnumber	IO1	1
XXppppSMSNOB1Vnumber	IO1	1
XXppppSMSNOA2Vnumber	IO2	2
XXppppSMSNOB2Vnumber	IO2	2
XXppppSMSNOA3Vnumber	IO3	3
XXppppSMSNOB3Vnumber	IO3	3
XXppppSMSNOA4Vnumber	IO4	4
XXppppSMSNOB4Vnumber	IO4	4
XXppppSMSNOA5Vnumber	IO5	5
XXppppSMSNOB5Vnumber	IO5	5
XXppppSMSNOA6Vnumber	IO6	6
XXppppSMSNOB6Vnumber	IO6	6
XXppppSMSNOB7Vnumber	IO7	8
XXppppSMSNOB7Vnumber	IO7	8
XXppppSMSNOB8Vnumber	IO8	9
XXppppSMSNOB8Vnumber	IO8	9
pppp	Four digits of current PIN
Number *2)	Maximum 14 digits of cell phone number

*1) The space is between key word of command and number

*2) Number can be entered in national format – e.g. 606445566 but also in international format – e.g. +420606445566.

If you want to deactivate the number set command without number – tm. e.g. XXppppSMSNOA3 without further parameters.

4.10. OUT – Set-up of Level of Outputs by SMS messages

Required logical level of outputs No. 1 to 8 can be set by incoming SMS message. If output is set to logical value 0 it is not possible to activate it as input.

Command *1)	Output	Order on the
		terminal board
XXppppOUT1Vy	IO1	1
XXppppOUT2Vy	IO2	2
XXppppOUT3Vy	IO3	3
XXppppOUT4Vy	IO4	4
XXppppOUT5Vy	IO5	5
XXppppOUT6Vy	IO6	6
XXppppOUT7Vy	IO7	8
XXppppOUT8Vy	IO8	9
pppp	Four digits of current PIN
y	Figure 0 or 1 determines logical level of output
	By sending value 0 output is set to 0V
	By sending value 1 output is set to 4-5V

*1) The space is between key word of command and value of parameter “y”

All outputs are set to logical level 1 (4–5 V) from production.

Inputs can be therefore activated.

15